User manual ALTEC LANSING VS4121

[. . . ] The terms of this warranty apply only to PC audio, TV or gaming speaker systems when such speakers are returned to the respective authorized Altec Lansing Technologies, Inc. Under the terms of this warranty, the original consumer purchaser has certain legal rights and may have other rights, which vary worldwide. Insert the wide blade into the ground side slot. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that product heat. [. . . ] WARNING: The subwoofer is NOT magnetically shielded, so it must be kept at least 2 feet (0. 6m) from PC monitors, TV sets, computer hard drives, or any other magnetic media (floppy discs, computer or audio tapes, etc. ) The subwoofer is non-directional, so it doesn't need to be placed in any particular location. Putting it on the floor close to a wall or in a corner will maximize bass efficiency and be sure to provide it with proper ventilation. arrange the satellite speakers to suit your listening tastes. The speakers are magnetically shielded, and can be placed close to a PC monitor or TV set without distorting the image. Master Volume The knob labeled VOL on the front of the right satellite is the master volume control for the speaker system. turn the knob clockwise to increase the volume and counter-clockwise to decrease the volume. Treble The treble level for the system is located on the front of the right satellite. Rotating this control knob clockwise increases the treble, while rotating the control knob counter-clockwise decreases the treble. Bass The bass level for the subwoofer is located on the front of the right satellite. Rotating this control knob clockwise increases the bass, while rotating the control knob counter-clockwise decreases the bass. WARNING: Do not insert the system's power plug into an AC outlet until all other connections are made. And turn off audio sources before connecting them to the VS4121's inputs. To ensure first-time operation as expected, please carefully follow the connection sequence described below. Connect the left satellite speaker (with a thinner cable and a brown RCA connector) to the brown input on the back of the subwoofer, labeled LEFT. Connect one end of the audio input cable (with lime green connectors at each end) to the matching lime green input plug on the back of the subwoofer, labeled INPUT. Connect the other end of the audio input cable to your desired audio source. To use headphones with the system, plug them into the labeled jack on the side of the right satellite. When headphones are connected, both satellites and the subwoofer are muted. [. . . ] Volume on your audio source set too high. Lower the volume or bass level on your computer, portable audio device, etc. increase the volume on the audio source. Check to make sure all cables are connected properly and are making a clear connection. [. . . ]