User manual AMERICAN AUDIO DX4

[. . . ] MIC 1 MASTER LEVEL LEFT RIGHT PHONO 1 PHONO 2 LINE 3 LINE 5 LINE 1 LINE 2 LINE 4 LINE 6 +5 0 -5 -10 -15 -15 -10 -5 0 +5 POWER 0 10 MIC 1 VOLUME 5 5 5 5 5 5 5 5 0 10 0 10 0 10 0 10 BASS MID LOW MID HIGH TREBLE CUE CUE CUE CUE 0 10 0 10 MIC 2 VOLUME MASTER LEVEL 0 10 CUE PGM 0 10 ASSIGN CH ASSIGN CH BOOTH LEVEL CUE MIXING CUE LEVEL PHONES DX4 TM Professional Preamp Mixer 4295 Charter Street Los Angeles Ca. 90058 www. americandj. com AMERICAN AUDIO DX4TM Unpacking Every DX4TM has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your mixer for any damage that may have occurred during shipping and be sure all accessories necessary to operate the unit have arrived intact. [. . . ] To monitor the master output signal turn the knob to the "PGM" position to monitor a channel signal turn the knob to the "CUE" position. To vary the amount of either signal turn the knob more or less to the center position. If the knob is set to the center position, you can monitor both the cue and master output levels equally. CUE LEVEL VOLUME CONTROL - This knob adjusts the headphone volume output level. Turning the knob in clockwise direction will increase headphone volume output. HEADPHONE JACK - This jack is used to connect your headphones to the mixer allowing you to monitor the cue source. Use headphones only rated at 8 ohms to 32 ohms. Most DJ headphones are rated at 16 ohm, these are highly recommended. Always be sure the CUE LEVEL VOLUME (12) is set to minimum before you put the headphones on. ©American Audio® - www. americandj. com - DX4TM Instruction Manual Page 6 DX4TM Controls and Features Cont. Rear Panel 17 18 19 20 21 22 23 24 22 AMERICAN AUDIO PREAMP MIXER MODEL NO. DX-4 AC 18V ~ 50/60HZ 20W CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS:RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR. 25 26 27 28 29 30 31 17. POWER CONNECTION - This connector is used to supply main power to the unit via the included detachable power adaptor. This cord is designed to fit in one direction only. Do not attempt to force a cord in if it does not fit, be sure the cord is being inserted properly 18. BALANCED XLR MASTER OUTPUTS - The Master Output includes a pair XLR Balanced JACKS as well as a pair RCA UNBALANCED JACKS (19). The 3-pin XLR jacks send a high current balanced output signal. These jacks should be used when you will be driving an amp or other audio equipment with a balanced input, or whenever you will be running a signal line greater than 15 feet. Always, use these jacks whenever possible. RCA MASTER OUTPUTS - The Master Output includes a pair XLR BALANCED JACKS (18) as well as a pair RCA Unbalanced Jacks. The RCA jacks send a low current unbalanced output signal. These jacks should only be used for shorter cable runs to signal processors or looping to another mixer. For cable runs greater than 15 feet use the XLR BALANCED JACKS (18). CHANNEL 4: LINE 6 INPUT JACKS - These Jacks are used for line level inputs. [. . . ] If the mixer is under warranty, you must provide a proof of purchase invoice. number by contacting our customer support team on out toll free number. DX4TM Main Features 2-YEAR LIMITED WARRANTY A. American Audio® hereby warrants, to the original purchaser, American Audio® products to be free of manufacturing defects in material and workmanship for a period of 2 Year (730 days) from the date of purchase. This warranty shall be valid only if the product is purchased within the United States of America, including possessions and territories. [. . . ]