User manual AMERICAN AUDIO Q-2422

[. . . ] The arising condensation of water might damage your device. Leave the device switched off until it has reached room temperature. Never put any liquids on the mixer or close to it. Should any liquid enter the device, disconnect from main power immediately. [. . . ] may also be connected to the LEFT & RIGHT RCA PHONO/AUX jacks (26, 27) on the rear of the unit. You can only control this signal after you have switched the PHONO / AUX SELECTOR SWITCH (29) on the rear panel to AUX, plus you must change the PHONO/AUX/LINE SWITCH (5) on the front panel to PHONO/AUX. The signal is then controlled via the CH1 and CH-2 faders (6). American DJ® AUDIO · Q-2422 User Instructions page 4 Functions (Front Panel) 15 22 5 4 3 21 2 20 24 16 1 19 10 18 6 17 8 7 9 13 11 12 14 23 (1) POWER SWITCH - Red LED will light when power is ON. (2) MASTER LEVEL - Dual LED's show the level of the left and right master output. (3) GAIN CONTROL - Used to set the level of the output signal for its designated channel. (4) BASS/MID/TREBLE CONTROL - Used to increase or decrease the LOW's, MID's, and HI's of the output signal. The Q-2422 features "Rotary Kills" with -35dB to +15dB output control. (5) PHONO/AUX/LINE SWITCH - Used to select the input to be sent to the individual channel. Channels 1 and 2 may be switched PHONO/AUX or LINE. Channel 3 may be switched LINE 3 or LINE 4. The selectors for AUX1/PHONO1 and AUX2/PHONO2 are on the rear panel (29). (6) CHANNEL FADER - Used to adjust the output level of each channel. (7) CUE BUTTONS - Engage the CUE button to monitor the assigned channel. (8) FEATHER FADERTM CROSSFADER - Mixes the signals of the assigned channels. To assign channels use the ASSIGN SWITCH (17) located on either side of the crossfader. When the crossfader is set in the center position, both assigned channels can be heard at once. (9) ON/OFF "Q" START- Start and stop the CD Player with the slide of the fader. The ON/OFF "Q" START (9) switch activates this FADER "Q" START feature. When in the ON position, the FADER "Q" START allows the signal to return automatically to preset digital CUE POINTS on your American DJ CD Player* (* also featuring FADER "Q" START). For example, each time you slide the crossfader to far left, the CD Player will be triggered to play the song from the beginning of the preset CUE POINT. Refer to your American DJ CD Player User Manual for setting CUE POINTS. Turn the ON/OFF SWITCH (9) to the OFF position to disengage the "Q" Start function and resume to a normal fader. [. . . ] Great for Touch Panels and Chase Controllers. (38) BOOTH OUT - Left and right RCA output jacks controlled by the ZONE (23, 24) controls on the front panel. (39) BALANCED OUTPUT - Balanced XLR-plug output for the master signal. Replacing the Crossfader · Disconnect from main power supply · Remove the fader knob. · Take the fader out and unplug the connection cables. [. . . ]