User manual AMERICAN AUDIO VX

[. . . ] Professional Power Amplifiers AmericAn Audio® 6122 S. 90040 6/09 VX Series User Instructions This symbol is intended to alert the user to the presence of non insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CaUtIon: risk of the electrical shock - Do not open! [. . . ] This is not advantageous to most users that want to reconfigure their systems or quickly change out an amp. The neutrik Speakon® connector provides the most convenient solution to this problem, eliminating the need for spade plugs or bare wire end cables. major speaker manufacturers have been using Speakon connectors on their products for years, so chances are you are ready to use the Speakon connection. With Speakon connectors, you can connect straight from the amplifier to the speaker. The Speakon connector used on this amplifier meets all known safety regulations. Once wired correctly, the connector cannot be plugged in backwards, causing the type of inverted polarity situations that have become common with banana hookups. This connection will provide a safe, secure and reliable method of connecting your speakers to your new amplifier. You can purchase the Speakon® NL4FC connectors from your local audio dealer. ©American Audio® - www. americanaudio. com - vX SeriesTM power Amplifier user manual page 9 SPeakon aSSeMBLy: You will need a pair of Neutrik Speakon® NL4FC connectors. You will also need high-quality two or four conductor speaker cable, a pair of needle-nosed pliers and a 1. 5-mm Allen key to assemble the Speakon connectors to your speaker wire. To assemble the neutrik Speakon NL4FC connector, complete the following steps: 1. Strip back 3/4-inch of the cable casing. Strip off 1/4-inch from the end of each of the conductors down to bare wire, and insert the brass fittings. Slide the cable tension clip (d) and the speakon coupler (e) through the cable end. Insert each wire with the brass fittings into the top of appropriate slot of the connector insert (B) as shown in Figures 9 and 10. Use a 1. 5-mm Allen key to tighten the connection. Be sure to properly match the positive (+) and negative (­) leads of each wire. For Bridge-Mono connection see Figure 12. Slide the connector insert (B) into the connector housing (A), making sure that the large notch on the outer edge of the insert lines up with the large groove on the inside of the connector housing. The insert should slide easily through the housing and out the other side until it extends approximately 3 /4-inch from the end of the housing. Slide the cable tension clip (d) along the cable and insert into the housing (A), making sure that the large notch lines up with the large groove on the inside of the connector housing (A). The cable tension clip (d) should slide easily into the housing until only 3 /8-inch of the cable tension clip (D) extends from the back end of the connector. Slide the coupler (E) along the cable and screw it onto the end of the housing (A). [. . . ] number by contacting our customer support team on our toll free number. please contact American Audio® customer support at (800) 322-6337 for a r. A. number on the outside of the package will be returned to the shipper. American Audio® hereby warrants, to the original purchaser, American Audio® products to be free of manufacturing defects in material and workmanship for a period of 1 Year (365 days) from the date of purchase. [. . . ]