User manual AMERICAN AUDIO XDM-2221

[. . . ] The arising condensation of water might damage your device. Leave the device switched off until it has reached room temperature. Never put any liquids on the mixer or close to it. Should any liquid enter the device, disconnect from main power immediately. [. . . ] to the LEFT & RIGHT RCA LINE signals (17, 18) to the AMP OUT jacks (17, 18) on the rear panel. The signal is then controlled via the CH-1 and CH-2 faders (6) when the PHONO/AUX/LINE SWITCH on the front panel (5a, 5b) to LINE . may also be connected to the LEFT & RIGHT RCA PHONO/AUX jacks (17, 18) on the rear of the unit. You can only control this signal after you have switched the PHONO / AUX SELECTOR SWITCH (19) on the rear panel to AUX, plus you must change the PHONO/AUX/LINE SWITCH (5a, 5b) on the front panel to PHONO/AUX. The signal is then controlled via the CH-1 and CH-2 faders (6). XDM-2221 "SKILZ" User Instructions page 4 Functions (Front Panel) 4 2 3 1 13 15 10 5a 11 12 8 5b 14 6 7 9 (1) POWER SWITCH - Red LED will light when power is ON. (2) MASTER LEVEL - Dual LED's show the level of the left and right master output. (3) GAIN CONTROL - Used to set the level of the input signal for its designated channel. (4) BASS/MID/TREBLE CONTROL - Used to increase or decrease the LOW's, MID's, and HI's of the input signal. The Q-2221 features "Rotary Kills" with -30dB to +20db input control. (5a) CHANNEL 1 TRANSFORMER SWITCH (CHANGEABLE) - Used to select the input to be sent to channel 1. TRANSFORMER SWITCH may be used up/down or left/right. To change the switch, see diagram on page 7. (CHANGEABLE) - Used to select the input to be sent to channel 2. TRANSFORMER SWITCH may be used up/down or left/right. To change the switch, see diagram on page 7. (6) CHANNEL FADER - Used to adjust the output level of each channel. (7) FADER CURVE SWITCH - Changes Feather FaderTM Crossfader from a NORMAL CURVE to a QUICK CURVE (used for crabbing). (8) PFL/CUE BUTTONS - Use the PFL (Pre-Fader Levels)/CUE button to engage the input level of each channel. (9) FEATHER FADERTM CROSSFADER - Mixes the signals of channel 1 and channel 2. When the crossfader is set in the center position, both channels can be heard at once. XDM-2221 "SKILZ" User Instructions page 5 Functions [Front Panel) Cont. (10) TALKOVER BUTTON - Press the talkover button when you want to use the microphone. When the button is pressed, all signals except the microphone level are decreased by l5dB. [. . . ] BASS & TREBLE can be adjusted by the DJ MIC BASS CONTROL KNOB (15) and the DJ MIC TREBLE CONTROL KNOB (15). Only replace the fuse when the device is disconnected from main power supply. Only replace with fuses of the same power and rating. (24) AC CONNECTION - Standard IEC plug with detachable AC power cord. [. . . ]