User manual AMERICAN AUDIO XDM-241

[. . . ] Leave the device switched off until it has reached room temperature. Never put any liquids on the mixer or close to it. Should any liquid enter the device, disconnect from main power immediately. Have the device checked by a qualified service technician before operating again. [. . . ] Never use solvents or abrasive detergents to clean the mixer!It is recommended that you use a soft damp cloth. Please consider that unauthorized modifications on the device are forbidden due to safety reasons! Connections (Refer to diagrams on pages 3 & 4) · Make sure that the power switch (1) is set to OFF. Before connecting other devices to the mixer, all units have to be switched off and the Master Control (11) set to min. · Make sure that the available voltage is the correct voltage (10 Volts) before connecting to power. · In order to obtain the highest sound quality, use high quality American DJ® Ameri-CableTM cables for connecting devices. Make sure that the cables are properly fixed. · Connect your amplifier to the OUT AMP jacks (16). · For recording, connect your tape recorder or cassette deck to the OUTPUT REC jacks (15). The REC OUT level will not be influenced by the Master Control (11). · Connect your microphone to the Microphone Input (10). (See diagram) · Connect your turntable(s) to the PHONO 1 jacks (13) or the PHONO 2 jacks (14) on the rear panel. You can only control the record player signal after switching the PHONO/LINE switches (2) to phono. The signal is then controlled via the CH-1 and CH-2 faders (3). · Connect your tape recorder, tuner, sound effects, CD player, cassette deck or any other line signals to the PHONO/LINE jacks (13 & 14) on the rear panel. You can only control the line signals after switching the PHONO/LINE switches (2) to LINE. The signal is then controlled via the CH-1 and CH-2 faders (3). © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. XDM-241 User Instructions page 2 Functions 1 8 ® 5 SHREDDER SCRATCH MIXER 10 MASTER LEVEL +5 +5 11 10 POWER 0 0 0 MASTER -5 -5 7 PHONES -10 -10 5 9 2 MIC 5 -15 L dB R -15 5 0 10 0 10 DJ MIC PHONO 1 LINE 1 PHONO 2 LINE 3 CUE LEVEL LINE 2 LINE 4 2 6 3 CUE channel 2 ch1 ch2 channel 1 3 XDM-241 PREAMP MIXER ch1 FEATHER FADER CROSS FADER PROformer Series ch2 4 (1) POWER SWITCH (2) LINE/PHONO SWITCH - Used to select the input (LINE or PHONO) to be sent to channel 1 or 2. Can also be used for TRANSFORMER SCRATCHING. (3) CHANNEL FADER CHANNEL 1 / CHANNEL 2 - Used to adjust the input level of each channel. (4) CROSSFADER - Mixes the signals of channel 1 and channel 2. When the crossfader is set in the center position, both channels can be heard at once. [. . . ] Connect with the input of power amplifier. (17) GND (Ground Terminal) - Connect this terminal to ground lead of the turntable. This helps to reduce humming and popping noises. (18) LINE/PHONO SELECTOR - Used to switch the channel input jacks to line or phono. © American DJ® AUDIO Los Angeles, CA 90058 USA Specifications subject to change without notice. [. . . ]