User manual AMERICAN AUDIO XDM-250T

[. . . ] American Audio® XDM-250T "TURNTABLE PRO" TM Professional Preamp Mixer American Audio 4295 Charter Street Los Angeles Ca. 90058 www. americandj. com XDM-250TTM Unpacking Every XDM-250TTM has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your mixer for any damage and be sure all equipment necessary to operate the mixer has arrived intact. [. . . ] When a Cut Button is depressed a LED located directly above the specific button will glow indicating the cut function has been activated. Pressing the Cut Button once again will disengage Cut function. ©American Audio® - www. americandj. com - XDM-250TTM Instruction Manual Page 4 XDM-250TTM Controls and Features Cont. 5. Channel 1 Bass Control - This control is used to increase (+20dB) or decrease (-30dB) the low frequency volume applied to the channel one source signal. Turn the knob counter-clockwise to decrease a value or clockwise to increase a value. Channel One Source Selector Switch - This two position switch is used to select the input source assigned to channel one. Each channel may only be assigned one input source at a time. Cue Selector Switch - This three position switch is used to send a channel source signal through to the headphone output. In the center position (1+2) both channels, one and two, will be audible through the headphones. The headphone volume level be controlled by the Cue Level (1) control. Channel One Fader - This fader is used to control the output signal of any source assigned to its particular channel. Feather Fader PlusTM Crossfader - This fader is used to blend the output signals of channels 1 and 2 together. When the fader is in the full left position (channel 1), the output signal of channel one will be controlled by the master volume level. The same fundamentals will apply for channel two, sliding the fader from one position to another will vary the output signals of channels one and two respectively. When the crossfader is set in the center position, the output signals of both the channels 1 and channels 2 will be even. Microphone Input Jack - This jack is used to a connect a microphone to the mixer. Connect your mic via a 1/4 inch (6. 3mm) jack. The mic signal volume will be controlled by Mic Level volume controller (2). Headphone Jack - This jacks is used to connect a set of stereo headphones to the mixer. Use headphones only rated at 8 ohms to 16 ohms. Most DJ headphones are rated at 16 ohm, these are highly recommended. Always be sure the Cue Level Volume (1) is set to minimum before you put the headphones on. Hamster Switch - Changes the polarity of the Crossfader (for crabbing). [. . . ] If the mixer is under warranty, you must provide a proof of purchase invoice. number by contacting our customer support team on out toll free number. XDM-250TTM Main Features 2-YEAR LIMITED WARRANTY A. American Audio® hereby warrants, to the original purchaser, American Audio® products to be free of manufacturing defects in material and workmanship for a period of 2 Year (730 days) from the date of purchase. [. . . ]