User manual AMX COLOR ACTIVE VIDEO TOUCH PANEL (G3 FIRMWARE)

[. . . ] instruction manual 6" Color Video Touch Panels (Firmware version G3) Touc h Pa n els an d A cc e ss o r ie s AMX Limited Warranty and Disclaimer AMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX Corporation, with the following exceptions: · · · Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year. Disk drive mechanisms, pan/tilt heads, power supplies, and MX Series products are warranted for a period of one (1) year. AMX Lighting products are guaranteed to switch on and off any load that is properly connected to our lighting products, as long as the AMX Lighting products are under warranty. AMX Corporation does guarantee the control of dimmable loads that are properly connected to our lighting products. [. . . ] Adding text, icons, and bitmaps to a button 1. Press BUTTON on the Edit bar to open the BUTTON menu. Press TEXT/IMAGE to add text to the button. Press any button to open the Text/Image page. 26 6" Color Video Touch Panels Designing Touch Panel Pages 4. Go through each option and set as desired: TEXT OFF and TEXT ON sets the text for the button's Off and On state. ICON OFF and ICON ON sets the icon for the button's Off and On state. BITMAP OFF and BITMAP ON sets the bitmap for the button's Off and On state. MAKE ON SAME AS OFF sets the On and Off properties the same. You cannot create or edit buttons with Unicode fonts on the panel. Any use of the TEXT/IMAGE button to alter or create Unicode font supported buttons must be done in the TPDesign3 Touch Panel Design Program. 5. Press EXIT SAVE CHANGE to close the Text/Image page and return to the Main page. Using TPDesign3 to Download Bitmaps, Icons, and Fonts TPDesign3 allows you to download bitmaps, icons, and fonts into your touch panel from an existing touch panel program. Refer to the TPDesign3 Touch Panel Program instruction manual for more information. Use the Download to Panel button to download a project file. To download bitmaps, icons and/or fonts from an existing TPDesign3 project file: 1. Launch the TPDesign3 software program and open a project file that contains the desired bitmaps, icons, and fonts. Select File from the menu bar to open the File menu. In the File menu, click on Download to Panel, this opens the Download to Panel dialog box. Click on the Comm Settings tab to set the communications port, baud rate, and other settings. Then, click the Actions tab to set the communication mode and select which elements of the project file you want to download to the touch panel. In the What To Send area, select one or more of the available options (All Bitmaps, All Icons, All Fonts). Select the mode of communication with the touch panel (RS-232 and AXlink). Confirm that the correct panel is selected by verifying the ID values with the Base Address assigned to the touch panel in the Protected Setup page. [. . . ] 17 on page 15) into the opening below both sides of the faceplate. The elevated groove on the blocks should lie against the base enclosure. Insert two of the provided enclosure screws into each of the mounting blocks and secure the bracket to the faceplate by turning the screws using a clockwise motion. Repeat this step for the second mounting bracket. AXD-CV6 Battery Replacement To remove the lithium battery from the touch panel: 1. [. . . ]