User manual AMX COLOR TOUCH PANELS WITH AUDIO (G3 FIRMWARE)

[. . . ] instruction manual CP4/A - 4" Color Touch Panels with Audio (Firmware version G3) Tou c h Pa n els an d A cc e ss o r ie s AMX Limited Warranty and Disclaimer AMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX Corporation, with the following exceptions: · · · Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year. Disk drive mechanisms, pan/tilt heads, power supplies, and MX Series products are warranted for a period of one (1) year. AMX Lighting products are guaranteed to switch on and off any load that is properly connected to our lighting products, as long as the AMX Lighting products are under warranty. AMX Corporation does guarantee the control of dimmable loads that are properly connected to our lighting products. [. . . ] An adjustment to this mode is also achieved through the use of the PBIL AXlink Send_Command. Refer to page 49 for more information. PIR/LS AUTO mode is a combination of the first two automatic mode buttons (PIR and LS button illumination). An adjustment to this mode is also achieved through the use of the PBIL AXlink Send_Command. The order of precedence for illumination of the pushbutton LEDs is PIR then LS. The pushbutton LEDs illuminate if there is PIR activity, without regard to the level 36 4" Color Touch Panels with Audio Designing Touch Panel Pages of the light sensor. The LEDs also illuminate if there is no PIR activity and the light sensor level falls below its threshold value. The order of precedence for turning Off the pushbutton LEDs is the LS then PIR. If the light sensor rises above its hysteresis (turn-on) value and there is no any activity coming from the PIR (thirty seconds of inactivity), the LEDs turn Off. Using the Audio and IR Device Setup page The speaker volume control, microphone control, and the IR device codes will be facilitated through a Audio And IR Device Setup Page. This page is used to configure the various features and parameters for the CP4/A panel sensors. From the Main page press the SETUP button. Press ADJUST SENSORS from the Setup page (FIG. Press AUDIO AND IR DEVICE SETUP from the Adjust Sensors page (FIG. Choose from any of these buttons and sliders to alter and set the properties for the speakers, IR receiver, and microphone (FIG. 31 Adjust Sensors page SPEAKER VOLUME allows the user to adjust the effective speaker volume. The panel consists of an up button (UP), a down button (DN), and a current setting indicator (range is between 0 and 32). The Speaker Volume up and down buttons adjust the Speaker Volume. An adjustment to the speaker volume is also achieved through the use of the SVOL AXlink Send_Command. Refer to page 50 for more information. MICROPHONE ADJUSTMENT allows the user to adjust the effective microphone volume. The panel consists of an up button (UP), a down button (DN), and a current setting indicator (range is between 0 and 32). The Microphone Adjustment up and down buttons adjust the Microphone Volume. An adjustment to the speaker volume is also achieved through the use of the MVOL AXlink Send_Command. Refer to page 48 for more information. 4" Color Touch Panels with Audio 37 Designing Touch Panel Pages SPEAKER DEVICE # assigns a device number to the speaker. [. . . ] From a plasterboard (drywall) surface, carefully unscrew the two #6 screws from the drywall clips. Once these drywall clips are separated from their screws, the drywall clip set must be re-order from AMX before the unit can be mounted to this type of surface again. Carefully removed any connectors from the rear of the AXD unit. Remove the four #4-20 securing screws (FIG. [. . . ]