User manual AMX MAX-CSD ENCODER

[. . . ] instruction manual MAX-CSE MAX Video Encoder AMX Limited Warranty and Disclaimer AMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX Corporation, with the following exceptions: · · · Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year. Disk drive mechanisms, pan/tilt heads, power supplies, and MX Series products are warranted for a period of one (1) year. AMX Lighting products are guaranteed to switch on and off any load that is properly connected to our lighting products, as long as the AMX Lighting products are under warranty. AMX Corporation does guarantee the control of dimmable loads that are properly connected to our lighting products. [. . . ] Once the particular System Master is configured for communication via an IP Address, remove the DB9 connector from the Program port on the NI on-board Master. Click Reboot (from the Tools > Reboot the Master Controller dialog) and wait for the System Master to reboot. The STATUS and OUTPUT LEDs should begin to alternately blink during the incorporation. Wait until the STATUS LED is the only LED to blink. Press Done once until the Master Reboot Status field reads *Reboot of System Complete*. Click the OnLine Tree tab in the Workspace window and right-click the associated System number and select Refresh System. This establishes a new connection to the specified System and populates the list with devices on that system. The communication method is then highlighted in green on the bottom of the NetLinx Studio window. If the connection fails to establish, a Connection Failed dialog appears. Try selecting a different IP Address if communication fails. Press the Retry button to reconnect using the same communication parameters. Press the Change button to alter your communication parameters and repeat steps 4 thru 18. 44 MAX Video Encoder Configuring Communication Associating the MAX unit to a Target Master Although the MAX-CSE unit can function independently of a NetLinx Master, the NetLinx Settings page allows a user (with sufficient access rights) to specify which Master is to be used for communication, query, and firmware updating. Access this page by clicking the NetLinx Settings link from within the Navigation frame. From within the Mode field, click on the drop-down arrow to reveal a listing of available NetLinx connection Modes which can be used when communicating with the target Master. For the purposes of these procedures, select URL (FIG. In the URL mode, you can only enter the IP/URL of the target Master. The System Number field becomes greyed-out and left at zero (for an unknown System Number) and the Master Port Number field is defaulted to 1319. NetLinx Master Connection Mode options: · LISTEN sets the MAX unit to "listen" for broadcasts from the Master. In this system, the MAX unit acts as a "Server" (in that Clients attach to it) and the Master acts as a "Client". · AUTO is used to instruct the MAX unit to search for a Master that both uses the same System Number (assigned within this page's System Number field) and resides on the same Subnet as itself. In this case, the Master has its UDP feature enabled. This UDP (User Datagram Protocol) is a protocol within the TCP/IP protocol suite that is used in place of TCP when a reliable delivery is not required. This UDP enabling is done through a Telnet session on the Master. [. . . ] Only use Mode 4 with channels 0 - 199. MAX Video Encoder 83 NetLinx Programming I/O Port Commands (Port 4) The I/O port is located at Port 4 in NetLinx D:P:S nomenclature. In these examples: <DEV> = device. The I/O port supports the following commands. I/O Send Commands Command GET INPUT Get the active state for the selected channels. Description An active state can be high (logic high) or low (logic low or contact closure). [. . . ]