User manual AMX NXA-TSJ45 AND NXA-MPS16F SURGE PROTECTORS

[. . . ] AMX LIMITED WARRANTY AND DISCLAIMER: AMX Corporation warrants this product to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX Corporation, with the following exceptions: Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year. Disk drive mechanisms, pan/tilt heads, power supplies, MX Series products, and KC Series products are warranted for a period of one (1) year. [. . . ] This includes any lost profits, lost savings, incidental damages, or consequential damages. AMX Corporation is not liable for any claim made by a third party or by an AMX Dealer for a third party. All products returned to AMX require a Return Material Authorization (RMA) number. The RMA number is obtained from the AMX RMA Department. The RMA number must be clearly marked on the outside of each box. After the 30-day period the RMA will be cancelled. Any shipments received not consistent with the RMA, or after the RMA is cancelled, will be refused. AMX is not responsible for products returned without a valid RMA number. This limitation of liability applies whether damages are sought, or a cliam is made, under this warranty or as a tort claim (including negligence and strict product liability), a contract claim, or any other claim. This limitation of liability cannot be waived or ammended by any person. This limitation of liability will be effective even if AMX Corporation or an authorized representative of AMX Corporation has been advised of the possibility of any such damages. This limitation of liability, however, will not apply to claims for personal injury. Some states do not allow a limitation of how long an implied warranty lasts. Some states do not allow the limitation or exclusion of incidental or consequential damages for consumer products. In such states, the limitation of the Limited Warranty may not apply. [. . . ] · Always keep cord lengths between equipment and protector to a minimum, try not to exceed 10 inches · Ground wires must be attached directly to metal chassis of equipment to be protected · Verify that metal equipment chassis are connected to earth ground via properly grounded AC outlet · Protectors reset after each surge. In the unlikely event of a catastrophic surge, the protector will self sacrifice and not allow damaging surges to reach your equipment NXA-TSJ45 informations: · Confirm power off to the equipment being protected · Disconnect incoming data · Connect the small cable to the end closest to the ground wire · Attach the green gound wire to the metal chassis · Attach the incoming wire to other suppressor opening · Apply power 4100-411 NXA-MPS16F information: · Remove power to unprotected equipment · Install the 19" rack mount unit to the rack · Verify rack grounding · Port 1 - Ethernet; all others are NetLinx · Disconnect incoming data line from equipment and connect to "in" port on the rack unit · Connect cable to corresponding "out" port and reconnect to equipment · Apply power to equipment [. . . ]