User manual AMX NXI NETLINX INTEGRATED CONTROLLER (CONTROLLER ONLY)

[. . . ] instruction manual NXI NetLinx Integrated Controller N e t L i n x C e n t ra l C o n t r o l l e r s a n d C a r d s AMX Limited Warranty and Disclaimer AMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX Corporation, with the following exceptions: · · · · · Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year. Disk drive mechanisms, pan/tilt heads, power supplies, MX Series products, and KC Series products are warranted for a period of one (1) year. Unless otherwise specified, OEM and custom products are warranted for a period of one (1) year. Software is warranted for a period of ninety (90) days. [. . . ] Displays a list of all devices present on the bus. SHOW DEVICE <D:P:S> NXI NetLinx Integrated Controller 11 Programming Program Port Commands (Cont. ) SHOW LOG Displays the log of messages stored in the Master's memory. The Master logs all internal messages and keeps the most recent messages. The log contains: · Entries starting with first specified or most recent. · Date, Day, and Time message was logged. · Which object originated the message. · The text of the message: SHOW LOG [start] [end] SHOW LOG ALL · If start is not entered, the most recent will be first. · If end is not entered, the last 20 messages will be shown. · If ALL is entered, all stored messages will be shown, starting with the most recent. SHOW NOTIFY Displays a list of devices that other systems have requested input from and the types of information needed. Note that the local system number is 1061. Displays a list of the devices this system requires input from and the types of information needed. When a NetLinx master connects to another NetLinx master, the newly connecting system has a device that the local system desires input from; the new system is told what information is desired from what device. Displays information about how this NetLinx master is connected to other NetLinx masters. Provides a list of all devices in all systems currently on-line. The system's lists are either directly connected to this master (i. e. 1 hop away), or are referenced in the DEFINE_DEVICE section of the NetLinx program. You may provide the desired system number as a parameter to display only that system's information (e. g. The systems listed are shown in numerical order. Displays the current time on the Master Card. Displays the list of URL addresses programmed in the Master Card. SHOW REMOTE SHOW ROUTE SHOW SYSTEM TCP LIST TIME URL LIST <D:P:S> ESC Pass Codes There are 'escape' codes in the pass mode. These codes can switch the display mode or exit pass mode. The following 'escape' codes are defined. Escape Pass Codes Command Description Exit Pass Mode: Typing a plus (shift =) followed by another plus followed by an ESC (the escape key) followed by another escape exits the pass mode. [. . . ] You can use the CTON to set pulse lengths and CTOF for time off between pulses. Syntax: SEND_COMMAND <DEV>, " 'SP', <IR OUT>" Variable: IR OUT = 1-252 and 256-65, 000 Example: SEND_COMMAND IR_1, " 'SP', 25" Pulses IR code 25 on IR_1 device. XCHM Changes the IR output pattern for the XCH command. Syntax: SEND_COMMAND <DEV>, 'XCH-<Mode>' Variable: Mode = 0-4 Example: SEND_COMMAND IR_1, 'XCH 3' Sets the IR_1 device's extended channel command to mode 3. [. . . ]