User manual AMX RDM-HDC HEAVY-DUTY DC MODULE, 2,400 W, 0-12 VDC

[. . . ] Installation Sheet RDM-HDC Heavy Duty DC Module 2400 W, 0-12 VDC The RDM-HDC Heavy Duty DC Module is a heavy-duty 2400 W module for dimming of fluorescent ballast loads. [. . . ] Use low-voltage wires with a 300 volt rating or greater. All electrical ratings are for continuous duty. Test loads for shorts before connecting. This module may require extra power from the AXlink connection or an external power supply connected to the control card. Connecting the RDM-HDC to the AMX Lighting Master Neutral High voltage Line in Load - out (LV) + out (LV) Low-voltage Pin 4 (GND) Pin 3 (RLY) Pin 2 (DIM) Pin 1 (+12 V) RDM-HDC 4-pin module connector GND 3 (-) 2 (DIM) 1 (+) 4-pin plug from RDM series module Note: The 4-pin plugs from the module connector to the 4-pin connector on the master (black plug cover facing up). 2 Connecting the RDM-HDC and AMX Lighting Master Lighting Application Drawings Neutral Line in (HOT) Low-voltage control wiring: 4-pin connector to AMX Lighting master controller + Florescent Ballast Ballast RDM-HDC Load Neutral CON LOAD LINE NEUT FIG. 1 RDM-HDC Low-voltage wire rated to 300 V RDM-HDC UL and C-UL Ratings · · · 120 VAC, 50/60 Hz, 2400 W 240/277 VAC, 50/60 Hz, 2400 W Control Out: 50 mA, 12 VDC sourcing/sinking Four-wire dimmable ballasts All low-voltage DC controlled ballasts Dimensions (HW): 10" x 2. 75" (25. 4 cm x 6. 99 cm) Non-phase dependant Use wires rated at 75°C (167°F) Torque terminals to 20 in-lbs. wire size: 10 AWG (4 mm²) Wire stripping length: 0. 28" (7 mm) Weight: 1. 3 lbs. (0. 590 kg) BTU/hr: 150 Control current: 150 mA @ 12 VDC Circuit breaker panel FIG. [. . . ] 3000 research drive, richardson, TX 75082 USA · 469. 624. 8000 · 800. 222. 0193 · fax 469. 624. 7153 · technical support 800. 932. 6993 [. . . ]