User manual ANDI PYROLYTIC AX100 MTPC

[. . . ] ELECTRIC BULT-IN OVEN 60 cm INSTALLATION, USE AND CARE INSTRUCTIONS PYROLYTIC AX100 MTPC 1 INDEX INSTALLATION INSTRUCTION GUIDE: BUILT-IN OVEN TO CABINET UNIT CHARACTERISTICS OF CABINET UNIT OVEN ELECTRICAL CONNECTION OVEN CLEANING OVEN DOOR REPLACING THE OVEN LIGHT SPARE PARTS APPLIANCE TECHNICAL FEATURES page 3 3 3 4 4 4 4 5 OVEN USE GUIDE: CONTROL PANEL LIGHT INDICATORS ELECTRONIC PROGRAMMER MANUAL TIMER OVEN TEMPERATURE THERMOSTAT SWITCH OVEN FUNCTION SELECTOR SWITCH BROIL USE SELF ­ CLEANING (ONLY FOR PYROLYTIC OVENS) OVEN RACK PLACEMENT OVEN MODES (HEAT SOURCE AND PATH) USE AND CARE INSTRUCTION FIGURES 5 5 5­6 7 7 7­8 8 8 9 9 10 ­ 11 2 USE AND CARE INSTRUCTION INSTALLATION INSTRUCTION GUIDE BUILT-IN OVEN TO CABINET UNIT: The oven may be built-in either in a column or under countertop of a suitable cabinet unit. Cut-out opening dimensions to be performed on cabinets are indicated in fig. Make sure cabinet unit in which the oven is to be fitted is sufficiently sturdy to take the weight of the appliance, approx. On the bottom of the unit and/or on the shelf supporting the oven, remember to do the cut-out section at the back, see fig. [. . . ] PYROLYTIC CYCLE Indicates when Oven self-cleaning cycle is on, see figure 11. Only on Pyrolytic ovens OVEN DOOR BLOCKING SYSTEM Indicates when Self-cleaning Door Locking System is on, see figure 12. ELECTRONIC PROGRAMMER The clock has a maximum setting of day time of 23h 59 Min. , Cooking End Time of 23h 59 Min. , Minute minder of 23h 59 Min. , and Cooking Period Time of 10h. Cooking duration C , Cooking end time selection C - S , Automatic programme S , Time of day, Minute minder B , A , Manual mode . Minus - , Plus + , Manual Displays: see figure 13. 4-digit 7-segment display for time of day and switching times. "Dialogue" display to identify condition of timer. 5 Setting: Select a function by pressing the function button and set the required time with + and - buttons. +/- Buttons: Pressing the + button increases the time set, pressing longer the button is held in the appropriate position. - decreases it. The count-up or countdown speed increases the Setting Time of Day: Select Time of day function by keeping C and S buttons pressed together while setting time of day with - buttons. Any programme, which has been set, is cancelled and the outputs switched on. Manual Operation: + and button and the Hand symbol will come on. Programmer just press the Programmer press C and S buttons together. The "A" symbol will be erased, the cookpot symbol C will come on. On both cases any programme, which has been set, is cancelled. Semi-Automatic Operation with cooking duration: Select C function and set required end time with the + and - buttons. The "A" and cookpot C symbols appear. If time of day = cooking end time the relay output and the cookpot symbol are switched off. The audible signal sounds and "A" blinks. Fully Automatic Operation: Select C function and set required duration with the + and - button. The relay is switched on and the cookpot symbol appears. Then select S function and the earliest possible end time is displayed. Set the required end time with the + and - buttons. The relay and the cookpot symbol are switched off. The cookpot symbol appears again when time of day = the calculated start time. [. . . ] Oven door is assembled with three tempered glasses, of which internal and middle glasses are Heat Reflecting type of glass. Forced fresh air is ducted through the door between external and internal glasses to cool down door external surface temperature. Oven door automatically locks during self-cleaning cycle because of the high temperature, to prevent burns caused by accidental door opening. Also, electrical power to appliance is automatically cut-off in case of oven malfunction for safety. [. . . ]