User manual AOC FT710

[. . . ] Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. [. . . ] The DDC2B is a bidirectional data channel based on the I²C protocol. The host can request EDID information over the DDC2B channel. USING THE RIGHT POWER CORD: The accessory power cord for the Northern American region is the wall plug with NEMA 5-15 style and is UL listed and CSA labeled. The voltage rating for the power cord shall be 125 volts AC. Supplied with units intended for connection to power outlet of personal computer: Please use a cord set consisting of a minimum No. 18 AWG, type SJT or SVT three conductors flexible cord. One end terminates with a grounding type attachment plug, rated 10A, 250V, CEE-22 male configuration. The other end terminates with a molded-on type connector body, rated 10A, 250V, having standard CEE-22 female configuration. TECHNICAL SUPPORT(FAQ) Power LED is not on *Power Cord should be connected No Plug & Play *Check if the PC System is Plug & Play compatible *Check if the Video Card is Plug & Play compatible *Check if the D-15 plug pin of Video Cable is bent *Make sure the AOC Monitor Drivers are installed (AOC Monitor Drivers are available at: www. aocmonitor. com) Picture is fuzzy *Adjust the Contrast and Brightness Controls. Picture bounces or a wave pattern is present in the picture *Move electrical devices that may cause electrical interference. The power LED is ON (orange) but there's no video or no picture. *Computer Power Switch should be in the ON position. *Computer Video Card should be snugly seated in its slot. *Make sure monitor's video cable is properly connected to the computer. *Inspect monitor's video cable and make sure none of the pins are bent. *Make sure computer is operational by hitting the CAPS LOCK key on the keyboard while observing the CAPS LOCK LED. The LED should either turn ON or OFF after hitting the CAPS LOCK key. Missing one of the primary colors (RED, GREEN, or BLUE) *Inspect the monitor's video cable and make sure that none of the pins are bent. INSTALLATION INSTRUCTIONS SWIVEL BASE To attach the swivel base to the monitor, do the following: · Carefully turn the monitor on its side or upside down. (see figure 1) · Locate the cavities at the bottom front of the monitor. · Insert the pegs on the swivel base into these cavities. Push the swivel base forward until the swivel base locks in place. · To remove the swivel base, hold the bottom of the swivel base, then push it out. Make sure the power cord is the correct type that required in your area. [. . . ] Adjust the picture's horizontal and vertical size simultaneously. Adjust the picture's trapezoid distortion. compensate the pincushion Adjust the picture to be a rectangle. Adjust the picture tilt to horizontal position. The color temperature for 6500°K is x=0. 313, y=0. 329 and 9300°K is x=0. 283, y=0. 297. [. . . ]