User manual APC BACK-UPS PRO 1200

[. . . ] Caution: The plug on the supply cord is the disconnect device for the product. The socket-outlet that you plug into shall be located near the equipment and shall be easily accessible. The socket outlet must be a grounding type. Press the Power On/Off push-button on the BackUPS. and Install Software (optional) Back-UPS (end view) ON LINE ON BATTERY REPLACE BATTERY OVERLOAD RJ-45 to USB Cable T0 Computer USB Port On Line (green) - is lit whenever facility power is powering the Battery Backup outlets. [. . . ] This is normal. Order Replacement Battery The typical battery lifetime is 3-6 years (depending on the number of discharge cycles and operating temperature). A replacement battery can be ordered over the phone from APC, or the battery can be ordered on-line from the APC web site (see below, a valid credit card is required). When ordering, please specify Battery Cartridge: 350 VA order RBC29, 500 VA order RBC30. 123 Place the unit on a flat surface. Press the battery cover latch and remove the battery cover. 4 Pull the battery out of the housing, exposing the battery wire and connector. Recycle the old battery. Transfer Voltage Adjustment (optional) In situations where the Back-UPS or connected equipment appears too sensitive to input voltage, it may be necessary to adjust the transfer voltage. This is a simple task requiring use of the front panel pushbutton. To adjust the transfer voltage, proceed as follows: 1. Plug the Back-UPS into the utility power source. The Back-UPS will be in a Standby Mode (no indicators lit). Press the front panel pushbutton fully inward for 10 seconds. All indicators on the Back-UPS will flash to acknowledge going into Programming Mode. Disconnect non-essential equipment from the Back-UPS. Reset the circuit breaker (located on the rear panel of the Back-UPS) by pushing the circuit breaker button fully inward until it catches. Service Circuit Breaker The wall outlet that the Back-UPS is Connect the Back-UPS to another wall outlet or have a qualified connected to does not supply facil- electrician check the building wiring. ity power to the unit. Note: If the UPS requires service, do not return it to the dealer. Consult the Troubleshooting section to eliminate common problems. Determine if the circuit breaker is tripped. If the circuit breaker is tripped, reset the breaker and determine if the problem still exists. If the problem persists, consult the APC Worldwide Web site (www. apc. com) or call customer service. · Record the model number of the UPS, the serial number, and the date purchased. Be prepared to troubleshoot the problem over the telephone with a technician. If this is not successful, the technician will issue a Return Merchandise Authorization Number (RMA#) and a shipping address. · If the UPS is under warranty, repairs are free. [. . . ] Use the template below to position the mounting fasteners (not supplied). Hold this page against the wall in the desired mounting location. Use thumbtacks or tape to hold this page in place against the wall. Use a sharp nail or pin to puncture the center of each template circle to mark the wall. [. . . ]