User manual APPLIED ENERGY LV 100PC

[. . . ] Please leave this leaflet with the fan for the benefit of the user Installing the fan These appliances are intended for connection to fixed wiring. If you have any queries before installing these products or after they have been installed, call the Xpelair Technical Hotline +44(0) 8709 000430. Our Engineers are there to help you during normal office hours (UK only) and may be faxed at all other times +44(0) 8709 000530. Customers outside the UK may contact your local Xpelair distributor. [. . . ] If installing in a wall, ceiling or vent Mark the position of the back plate B 1. Hold the back plate so that the terminal block faces you in the left hand corner, and the lip points towards the hole. Carefully insert the lip into the wall duct/ceiling or vent shaft. Adjust the position of the back plate until it is level. Mark on the wall/ceiling or vent shaft the positions of the three fixing holes in the back plate. Drill screw holes in these positions if necessary, and fit wall plugs if necessary. Push the ribbed gasket (RG100) onto the lip of the back plate 1 2. If installing in a ceiling or vent, push the larger diameter piece of the telescopic wall tube onto the ribbed gasket. Feed the mains cable through the cable entry hole in the backplate to the terminals D 4. If wiring from above, leave the cable free to be fitted into labyrinth. Insert the lip of the back plate into the wall duct/ceiling or vent shaft as before. Fasten the back plate to the wall/ceiling or vent shaft using appropriate fasteners. If using screws, do not overtighten the screws. Peel the backing from the foam strip supplied and attach it around the outside of the lip on the back draught shutter. Holding open the top and bottom vanes, insert the lip into the wall duct. Making sure the back draught shutter is level, mark the positions of the two fixing holes in the top right hand and bottom left hand corners. Remove the back draught shutters from the wall duct. Drill screw holes in these positions, and fit the remaining wall plugs. Holding open the top and bottom vanes, refit the back draught shutter and fasten it to the wall using the pointed end self-tapping screws. Make sure the vanes open and shut freely. If installing in a window or panel Sealing the hole E If installing in a window or panel no more than 9mm thick, fit the white rubber gasket around the edge of the hole. if installing in a panel or sealed double glazing more than 9mm thick , a DXG Double Glazing kit is required. [. . . ] During this time the fan will run for up to two minutes. Feeding the cable between the two raised pegs, if wiring from above and through the labrynth to the terminal block. For fixed wire and circuits the protective fuse for the appliance must not exceed 5A. To adjust the overrun timer insert a small screwdriver into the recess in the control spindle and turn clockwise to increase and anti-clockwise to decrease. [. . . ]