User manual APPLIED ENERGY PX12

[. . . ] Do's and don'ts · Do read the entire instruction leaflet before commencing installation. · Do install each fan with a double pole-isolating switch. · Do make sure the mains supply is switched off before attempting to make electrical connections or carry out any maintenance or cleaning PX6, PX9 and PX12 Commercial ceiling fans Guarantee Customers outside UK ­ see international below. · UK: The fan is guaranteed against defects for 2 years from the date of purchase. [. . . ] Note: Please check instructions for the controller. 8. Wire the electrical connections If installing a PX6: 1. Wire the switch cable into the fan's terminal connector as shown in diagram B2. If the Fan is wired from above, remove the fan's Terminal cover and feed the cable through the top cable entry. Ensure the outer sheath of the cable is retained in the labyrinth B1. If wiring from the rear, remove the fan's terminal cover and rear entry knockout, feed the cable through the knockout. Refit the inner grille to the fan mounting box, using fixi ng screws G1 (8). Insert two colour matching screw covers in the fixing holes in the inner grille. When removing the covers, place a 3mm blade electrician's screwdriver into the slot and lever off the cover. Switch off the mains electrical supply and remove fuses. Connect the cable from isolation switch to the electrical supply wiring. Replace the fuses, and switch on the mains electrical supply. For fixed wiring circuits the protective fuse for the appliance must n ot exceed 5A. The fan connector parts are packed separately. If required feed the cable through the grommet in order to fit the cable entry of the connector plate. · If installing with an on/off switch: 1. Set the Fan Selector Switch to position 1 for Intake, Position 2 for Extract or Position 3 for `open shutter only' (Fig D. ) · If installing with a controller: 1. Refer to the installation instructions for the controller. If wiring to an existing controller, contact Xpelair Technical Services or in export markets, the Xpelair distributor 3. Set the Fan selector Switch to position 3 if using a controller providing variable sp eed and/or direction. Otherwise, set the Fan Selector Switch to Position 1 for Intake, Position 2 for Extract or Position 3 for `open shutter only' (fig. Fitting the cable clamp (PX9/12): For cable up to 8mm diameter, clamp the cable as shown in Fig. For cable equal to or greater than 8mm and up to 11. 5mm diameter, clamp the cable as shown in Fig. [. . . ] Install the isolating switch and the on/off switch or controller if required. Make all connections within the isolating sw itch and the on/off switch if required. Note: Switches must be so situated that they cannot be touched by persons making use of the bath or shower. For Australia only These models are permanently connected to the supply and operation is controlled by a remote switch. [. . . ]