User manual APPLIED ENERGY XPLUS 250 DC

[. . . ] The guarantee on any exchanged parts or product ends when the original guarantee period ends. i) In the event of a product being returned to Applied Energy Products Limited and not found to be faulty, the product would be available for collection from the relevant premises within one month and if not collected it would be disposed of or delivered by Applied Energy Products Limited and a delivery charge made. EXCLUSIONS This guarantee DOES NOT cover damage or defects arising from poor or incorrect installation, improper use or lack of maintenance. [. . . ] If you have any queries before installing these products or after they are installed, call the Xpelair Technical Hotline +44 (0) 8709 000430. Our engineers are there to help during normal office hours (UK only) and may be faxed at all other times on +44 (0) 8709 000530. Customers outside the UK please contact your local Xpelair distributor, details of which are available from the UK office. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. For flexible ducting, you will need worm drive clips (available from Xpelair) to attach the ducting to the fan inlets and outlet. If installing in a position where condensation is likely to run back towards the fan, you will need a suitable condensation trap. Where to locate it Position of air intake Connecting the fan As far as possible from and opposite to the main source of air replacement to ensure airflow across the room (e. g. Not where ambient temperatures are likely to exceed 50oC, or above a cooker hob or eye level grill. If installing in a room containing a fuel burning device, it is the installer's responsibility to ensure that there is enough replacement air to prevent fumes being drawn down the flue when the fan is operating up to maximum extract. Refer to Building Regulations for specific requirements. Exhaust air must not be discharged into a flue used for exhausting fumes from appliances supplied with energy other than electric. Requirements of all authorities concerned must be observed for exhaust air discharge. When installed for use in possible chemical corrosive atmospheres, consult our Technical Service Department. (For overseas markets contact your local Xpelair Distributor). The inlet grilles should be situated at least 0. 5m distance from the discharge outlet of a flued heating or cooking appliance. Position of the fan 1. Switch off the mains electrical supply and remove fuses. The fan can be wired for direct operation as fig B1 or through an Xpelair XRH (fig B2), AQS (fig B3), COS switch (fig B4), DT20B (fig B5) or XPIRA (fig B6), where the controller provides the Boost function to the fan. [. . . ] Ducting long enough to connect from the position of the air intake positions to the air outlet via the fan. Ducting accessories, including internal and external grilles and fasteners. 1. 2. Mount the fan, using appropriate fasteners through the mounting holes provided. [. . . ]