User manual APRILIA DORSODURO 1200

[. . . ] We have drawn up this booklet to provide a comprehensive overview of your vehicle's quality features. Please read it carefully before riding the vehicle for the first time. it contains information , tips and precautions for using your vehicle. It also describes features, details and devices to assure you that you have made the right choice. [. . . ] Check that the throttle functions smoothly and can be fully opened and closed in all steering positions. Check that tyres are in good conditions. Check inflation pressure, tyre wear and potential damage. Remove any possible strange body that might be stuck in the tread design. Top-up the fluid if necessary; the clutch must work without gripping and/or sliding. Check that there is no resistance when the side stand is pulled up and down and that the spring tension makes it snap back to its rest position. lubricate couplings and joints if necessary. Check the safety switch for correct operation. Fluid level inside the expansion tank should be between the 'FULL' and 'LOW' reference marks. Engine stop switch (ON - OFF) Lights, warning lights, horn, rear stop light switch and electrical devices Tone wheels (only for vehicles with Check that the tone wheels are ABS system) perfectly clean Introduce the key (2) in the fuel tank cap lock (3). Turn the key anticlockwise, lift and remove the fuel filler cap. The fuel cap may only be refitted with the key (2) inserted. Once the key (2) is inserted, press the cap to close it again. To adjust the setting, the shock absorber has one set screw (1) to adjust rebound damping, a ring nut for spring preloading adjustment (2), a locking ring nut (3) and a set screw for adjusting compression damping (4). Turn the (1) screw to adjust the shock absorber hydraulic rebound damping. Medium load setting: - (for example, rider with passenger and/ or luggage). Rebound damping adjustment, screw (1) Compression damping adjustment, screw (4) Spring A length Spring preload, ring nut (2) Open 17 clicks from fully closed Open 1. 5 turns from fully closed Open 12 - 16 clicks from fully closed Open 0. 5 turns from fully closed Open 12 - 16 clicks from fully closed Open 0 - 1. 5 turns from fully closed The stroke should be soft and there should be no oil marks on the stems. Check the tightening of all the elements and the correct operation of the front and rear suspension joints. The front suspension consists of a hydraulic fork connected to the headstock by means of two plates. [. . . ] Height Saddle height Wheelbase Kerb weight Dry weight (unfuelled) 2248 mm (88. 0 : 1 starter 1400 ± 100 rpm Multiple-disk, oil-bathed clutch with control on the left side of the handlebar Wet crankcase. Pressure system regulated by a trochoidal pump with oil radiator. Type Mechanical, 6 speeds with foot lever on the left hand side of the engine Type Type Endless (without master link) and with sealed links. [. . . ]