User manual APRILIA RSV 1000 R

[. . . ] EPA AND CALIFORNIA REGULATIONS APPLICABLE TO 2004 MODEL YEAR NEW MOTORCYCLES AND IS CERTIFIED TO 1. 4 HC+NOx G/KM ENGINE FAMILY EXHAUST EMISSION STANDARD IN CALIFORNIA. ENGINE EXHAUST CONTROL SYSTEM: HO2S-2OC 0XIIOHU VWDPSLQJ Do not use any tire other than those reccomended and approved by Aprilia. Do not use any tire with less than 1/8" (3mm) tread remaining. Do not repair any tire, nor use repaired tire. [. . . ] If it falls over, it may cause damage to bystanders and other property, as well as be damaged itself. Rotate the wheel manually, so that the space between two spokes of the rims lines up with the brake caliper. Have a helper steady the handlebar in the straight ahead position. Brake caliper screw (9) tightening torque: 36. 16 ftlb (50 Nm). Remove the two screws (9) that fasten the front brake caliper (10). 10 9 Remove the brake caliper (10) from the disc, leaving it attached to its line (11). Operate on the second brake caliper: Repeat the operations marked with . REASSEMBLY Operate on the second brake caliper: Repeat the operations marked with . Remove the front support stand (7), see page 108 (PLACING THE VEHICLE ON THE FRONT SUPPORT STAND) . WARNING After servicing the brakes, always check that they operate correctly. If the stroke of the lever or pedal is excessive, or if you detect that the effectiveness of the brakes is reduced in any way, have your vehicle serviced by your Local aprilia Dealer. It may be necessary to have your dealer bleed the system, or there may be some other problem with the brake system. Never ride your vehicle in traf fic immediately after servicing the brakes. Refit the screw (13), the washer (14) and the nut (15) and tighten to the specified torque. NOTE Support the stand, in order to prevent it from accidentally falling down. NOTE Obtain a tie-wrap (7) to use for reassembly. CAUTION Do not force cables, tubes, lines, connectors and wires. Cut the tie-wrap (8) and release the cable (9). Disconnect the electric connector (10) from the connector (5). use and maintenance RSV 1000 R USA - RSV 1000 RFACT USA 125 12 If any fastener in the throttle system becomes loose, likewise you will lose control of your vehicle. Either situation can lead to an upset or collision with subsequent serious injury or death. Your vehicle is equipped with a double cable throttle. One cable opens the throttle when you rotate the throttle grip toward you; the other closes the throttle when you rotate the grip away from you. It is essential, when you release the throttle grip, that it automatically return to the idle position. This double cable arrangement enhances safety by providing for positive closing of the throttle. 11 3 4 2 1 NOTE Store away the complete stand, the screw (11) and the washer (12) together. This way, you will be able to refit them correctly when you intend to use the vehicle on public roads. Refit the left side fairing, see page 119 (REMOVING THE SIDE FAIRINGS). ADJUSTING THE THROTTLE CONTROL Carefully read p. This vehicle is equipped with two throttle cables. [. . . ] 0064-3-3667580 - Email: guzzi@motorcycling-nz. co. nz Old Pretoria Road - Wynberg - Johannesburg Tel. 0027-11-7868482 - Email: motovelo@betech. co. za San Jeromino - 64640 - 552 Monterrey N. L. 0052-8348-9398 - sbertuEmail: javier@aprilia. com. mx YeungSoo Bldg. 302 #206-25, Ohjang-Dong, Chung-Ku Seoul Tel. [. . . ]