User manual APRILIA RSVMILLE DEALER INSTRUCTION 2002

[. . . ] Possible risk of slight injury or damage to motor cycle. For the sake of safety, before starting the vehicle, carry out a thorough preliminary check. See the PRELIMINARY CHECK LIST IN THE VEHICLE OPERATION AND MAINTENANCE HANDBOOK. [. . . ] If the electrolyte is accidentally swallowed, drink large quantities of water or milk, and then milk of magnesia or vegetable oil. Immediately consult a health professional. The battery gives off noxious and explosive gases; keep it away from cigarettes, flames, sparks and any other source of heat. During the recharging or the use, make sure that the room is properly ventilated and avoid inhaling the gases released during the recharging. Do not tip the vehicle too much, or tip the battery too much, to avoid electrolyte leaking out. BATTERY INITIAL BATTERY CHARGING 1 2 CAUTION FITTING THE RETROREFLECTOR w Place the retroreflector (2) on the mudguard and secure with a self-tightening flanged nut (1) M5. FITTING THE LICENSE PLATE HOLDER w Place the license plate holder (3) on the mudguard (4) and secure with 3 screws M6 and 3 flanged nuts. w Remove the saddle, by unscrewing the screws (1). w Remove the cap (2) from the recharge container (3). w Place the container in the battery as shown in the drawing. w Use the same plug (2) to close up battery holes. FITTING THE BATTERY w Make sure the ignition key is in the position. w First connect the positive cable (+) then the negative (-). w Use a neutral grease or vaseline to grease terminals. REFITTING THE BATTERY AFTER FIRST RECHARGE CAUTION Wait 5-10 minutes after recharging and then fit the battery, since it continues to produce gas for a period after recharging. CAUTION The battery liquid is corrosive. Do not pour or sprinkle it, particularly on plastic parts. When the battery has been removed it must be placed in a safe place out of the reach of children. The battery is very dangerous and may cause serious injury or death. Pag. 7 RSV mille RSV mille R RSV mille RSV mille R INSTRUCTIONS FOR THE DEALER INSTRUCTIONS FOR THE DEALER FITTING THE FRONT WHEEL 8 DANGER Before carrying out any maintenance operation or inspection of the front wheel, if possible hoist the vehicle onto a solid and level surface with suitable equipment. [. . . ] w Fit the wheel and pin (1). 5 w Fit the screws (5) of the left-hand rod terminal to prevent the pin rotating. w Fit the washer (3) and secure the nut (4). Screw (4) tightening torque: 59, 0 ftlb (80 Nm). [. . . ]