User manual APRILIA SHIVER 750

[. . . ] We have drawn up this booklet to provide a comprehensive overview of your vehicle's quality features. Please read it carefully before riding the vehicle for the first time. it contains information , tips and precautions for using your vehicle. It also describes features, details and devices to assure you that you have made the right choice. [. . . ] Check the tightening of all the components and the correct operation of the front and rear suspension joints. The distance between the end of the lever (1) and the handgrip (2) can be adjusted by rotating the set screw (3). The MAX and MIN clicks correspond to a lever end-handgrip distance of about 114 mm (4. Push the control lever (1) forward and turn the set screw (3) until the lever (1) is at the desired distance. If necessary, the position of the levers can be personalised. Turn the cam (2) until the adequate position for the pedal (3) is obtained. The distance between the end of the lever (1) and the handgrip (2) can be adjusted by rotating the set screw (3). The MAX and MIN clicks correspond to a lever end-handgrip distance of about 118 mm (4. Push the control lever (1) forward and turn the set screw (3) until the lever (1) is at the desired distance. Engine run-in is essential to ensure engine long life and correct operation. Run in engine, brakes and suspensions effectively. In this way, you allow for the work of components to be "loaded" and then "unloaded", thus cooling engine parts. Do not twist the throttle grip abruptly and completely when the engine is working at a low revs, either during or after runin. During the first 100 km (62 miles) operate the brakes with caution, avoid rough and long braking. Starting up the engine (03_10, 03_11, 03_12, 03_13, 03_14, 03_15) This vehicle has remarkable power and should be used gradually and with maximum caution. Do not carry objects in the top fairing (between the handlebar and the instrument panel) so that handlebar can turn freely and the instrument panel is visible at all times. Make sure the light switch (1) is set to the low-beam light position. Turn the key (3) and set the ignition switch to ON. On the instrument panel, all warning lights (4) and the backlighting are on for 2 seconds. The rpm indicator (5) goes to the bottom of the scale and after 3 seconds, it goes back to the minimum value. Block at least one wheel by operating one brake lever. Operate the clutch lever (7) completely and set the gearshift lever (8) to neutral (green warning light "N" (9) on). [. . . ] After washing and drying the chain, lubricate it with spray grease for sealed chains. 0: 1 electric 1400 ± 100 rpm Multiple-disk, oil-bathed clutch with control on the left side of the handlebar Wet crankcase. Pressure system regulated by trochoidal pump with dry cartridge filter Type Mechanical, 6 speeds with foot lever on the left-hand side of the engine Type Fork oil quantity (for each stem): Coolant Seats Vehicle max. Type Endless (without master link) and with sealed links. [. . . ]