User manual APRILIA SR50 DITECH DEALER INSTRUCTION 2001

[. . . ] When you see this symbol on the motorcycle or instruction sheets, beware of potential injury hazards. Failure to observe the instructions following these symbols may affect your safety, the safety of others and that of the motor cycle!Possible risk of slight injury or damage to motor cycle. SR 50 Ditech SR 50 Ditech For the sake of safety, before starting the vehicle, carry out a thorough preliminary check. [. . . ] 1 aprilia DEALER INSTRUCTION SHEET 2 1 6 SR 50 DITECH aprilia 3 SR 50 DITECH DEALER INSTRUCTION SHEET 2 1 4 3 4 5 5 2 Do not tip the vehicle too much, or tip the battery too much, to avoid electrolyte leaking out. FITTING THE MIRRORS Fit the mirrors as follows. 1 CAUTION The battery liquid is corrosive. Do not pour or sprinkle it, particularly on plastic parts. When the battery has been removed it must be placed in a safe place out of the reach of children. The battery is very dangerous and may cause serious injury or death. INITIAL BATTERY CHARGING · To fit the right wing mirror position the gasket (1) marked "DX" and the mirror (2), then tighten with screw TCEI M 8x35 (3). Screw (3) tightening torque: 18, 44 ftlb (25 Nm) · Close the hole in the mirror with the rubber plug (4). · Do the same for the righthand mirror. A 4 5 B 3 6 CAUTION BATTERY Battery electrolyte is toxic, caustic and the contact with the skin may cause serious burns, since it contains sulfuric acid. Wear protective clothing, a face shield and/or tight fitting goggles when working around the battery. In case of contact with the skin, flush immediately with plenty of water. In case of contact with the eyes, flush with plenty of water for at least 15 minutes. If the electrolyte is accidentally swallowed, drink large quantities of water or milk, and then milk of magnesia or vegetable oil. Immediately consult a health professional. The battery gives off noxious and explosive gases; keep it away from cigarettes, flames, sparks and any other source of heat. During the recharging or the use, make sure hat the room is properly ventilated and avoid inhaling the gases released during the recharging. · Remove the tool kit cover (1) turning the key (2) clockwise. · Remove the tool kit carrier (3) and the battery (4). · Remove the plug (5) from the recharge container (6). [. . . ] · Tighten the two screws TCEI M 6x20 (7) of the wheel pin terminal to 8. 85 ftlb (12 Nm). CAUTION · Make sure the ignition key is in the " " position. · Place the battery into its housing. · First connect the positive cable (+ red) then the negative (- blue). [. . . ]