User manual ARCAM DT26

[. . . ] The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CAUTION: In Canada and the USA, to prevent electric shock, match the wide blade of the plug to the wide slot in the socket and insert the plug fully into the socket. CAUTION: Use of any controls, adjustments or procedures other than those specified herein may result in hazardous radiation exposure. important safety instructions 1) Read these instructions. 5) Do not use this apparatus near water. [. . . ] Use the '/, cursor keys on the remote control to highlight "now Playing" and press O. The playback controls nowaffect music playback. < Slide Show Effects: Use the '/, cursor keys to select one of the following effects: <Horizontal Scroll Rapid Playback <Fade Press ) or ( during playback to activate rapid <Shutter reverse or forward playback. Further button presses <none change the playback speed. Speeds of 2x, 4x, 8x, 16x, Press O to confirm the selection. 32x, 64x and 128x normal speed are available. < Slide Show Delay: Use the '/, cursor keys to select the delay time between pictures: displaying File information <5 seconds Press the STaTuS button to display the file information panel. The file information panel shows the following <2 seconds information: <1 second <none <10 seconds Current le/total le number <15 seconds File type Repeat playback mode Title <30 seconds File : 2 / 3 . . Press O to confirm the selection. 0 : 01 : 59 1 : 04 : 56 Off Off P lay Elapsed time Progress bar Random playback mode Total playing time Playback mode of current le Playing music whilst viewing pictures During the playback of music files, press the O button to display the Press status again to hide the file information panel. note that the file information panel is always shown when playing music files. Slideshow effects When viewing a JPEg picture slideshow, press the U button to display the Slideshow Menu: e-19 english S lide S how E ffec ts None Play menu. Use the '/, cursor keys on the remote control to highlight "Browse Pictures" and press O. Select pictures and play them as described in "The Play menu" on page E-18. Once the correct video settings have been entered, a higher-quality connection can be used. e-20 display TV Type ­ Set the video signal format. If the colour or picture quality of analogue video appears incorrect, change this setting. It should not need to be adjusted in normal use. < NTSC: USA and Canada video standard. < PAL: Europe, Australia and China video standard. Resolution ­ Set the video resolution of the HDMI and COMPONENT VIDEO outputs. < HDMI Auto: Sets the TV's preferred resolution. < 480p/576p: 480 lines (nTSC) or 576 lines (PAL) progressive video < 480i/576i: 480 lines (nTSC) or 576 lines (PAL) Standard Definition interlaced video. NOTE < The HDMI Auto setting may not set the best possible resolution. If you have a 1080p Full HD display, set the resolution to 1080p. < For full details of output resolutions available at different outputs, refer to the table on page E-25. [. . . ] SHOULD THE PrOgrAM PrOVE DEFECTIVE, YOU ASSUME THE COST OF ALL nECESSArY SErVICIng, rEPAIr Or COrrECTIOn. In nO EVEnT UnLESS rEQUIrED BY APPLICABLE LAW Or AgrEED TO In WrITIng WILL AnY COPYrIgHT HOLDEr, Or AnY OTHEr PArTY WHO MAY MODIFY AnD/Or rEDISTrIBUTE THE PrOgrAM AS PErMITTED ABOVE, BE LIABLE TO YOU FOr DAMAgES, InCLUDIng AnY gEnErAL, SPECIAL, InCIDEnTAL Or COnSEQUEnTIAL DAMAgES ArISIng OUT OF THE USE Or InABILITY TO USE THE PrOgrAM (InCLUDIng BUT nOT LIMITED TO LOSS OF DATA Or DATA BEIng rEnDErED InACCUrATE Or LOSSES SUSTAInED BY YOU Or THIrD PArTIES Or A FAILUrE OF THE PrOgrAM TO OPErATE WITH AnY OTHEr PrOgrAMS), EVEn IF SUCH HOLDEr Or OTHEr PArTY HAS BEEn ADVISED OF THE POSSIBILITY OF SUCH DAMAgES. EnD OF TErMS AnD COnDITIOnS How to Apply These Terms to Your new Programs If you develop a new program, and you want it to be of the greatest possible use to the public, the best way to achieve this is to make it free software which everyone can redistribute and change under these terms. To do so, attach the following notices to the program. [. . . ]