User manual ARCAM DV137

[. . . ] H A N DBOOK DV137 Arcam DV137 DVD player English Safety guidelines CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: To reduce the risk of electric shock, do not remove cover (or back). Refer servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated `dangerous voltage' within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] Note that this feature applies only to multi-title discs. AUDIO Some DVDs offer the facility to select different audio tracks. Press AUDIO to cycle through the available tracks. The on-screen display shows the number, language and type of audio track, e. g. RTN (return) Press RTN to move back through the DVD `Disc' and `Title' menus. Note that this feature is only of use with discs using multi-level menus. AUDIO TRIM TITLE RTN ZOOM Press ZOOM to enlarge a particular area of the picture. Each press of the ZOOM button increases the zoom, normally until a maximum of 4x enlargement is reached. Pressing ZOOM when the maximum enlargement has been reached returns the image to normal size. ZOOM ANGLE SUBT MODE MODE This button brings up a menu very similar to the `Audio' page of the Setup menu (as described on page 17) and allows the Dolby Pro Logic II settings to be changed while the disc is being played. RAND STATUS MEM SRCH RAND Press RAND to toggle random playback SRCH (search) It is possible to get access to any point on the disc directly using the `Search' menu. STATUS Press SRCH to access the `Search' menu. Press STATUS to give play status information about the current disc. Press STATUS again to close the status display. The status information displayed varies depending on the type of disc ­ DVD, CD or VCD. ANGLE Some DVDs offer the facility to select different camera angles. If this feature is available the `camera' symbol lights in the display. Press ANGLE to cycle through the available angles. DV137 E-11 E nglish Configuring your DVD player Introduction This section of the document describes the use of the `Set-up' menu, which is used to configure your player for your system and your personal preferences. Obtaining a picture To view the Set-up menu for the initial configuration, we recommend the use of the composite video output to connect to your display device. This is because the high quality video output has several display modes and may be incompatible with your display device in its default configuration. Ensure that your display device is switched on and that you have selected the correct video input. You should see the image shown on the right. This is the image that the DVD player gives whenever there is no disc playing. NOTE: To protect your screen from damage caused by persistent static images, a `screen saver' facility activates after a few minutes of inactivity. When this occurs, the image shown on the right will be `bounced' around the screen. To reset the image to the central position, press the STOP button on the player or on the remote control. Using the Set-up menus Your DV137 has two different set-up menus: < The Set-up menu allows configuration of all aspects of your DVD player. Configurable items and their potential values are described on the following pages. < The Display set-up menu is a series of video test patterns with instructions that will allow you to configure your display optimally for your DVD player. The Set-up menu The Set-up menu comprises six pages of options. The tabs on the left side of the screen show the pages available, indicating the nature of the items on each page. [. . . ] A CD-ROM used to compile your files must be ISO 9660 Level 1 or Level 2 compliant. CD physical format: Mode1, Mode2 XA Form 1, or Mode2 Form 2. File names up to 15 characters are supported. A DVD-ROM used to compile your files must be ISO 9660 Level 1 or Level 2 compliant. [. . . ]