User manual ARCAM DV88

[. . . ] HANDBOOK DV8 8 Arcam DV88 DVD player Lecteur DVD Arcam DV88 DVD-Spieler Arcam DV88 E nglis h Fra nça is D eut s ch Safety guidelines Safety instructions This product is designed and manufactured to meet strict quality and safety standards. However, you should be aware of the following installation and operation precautions: 9. Power sources Only connect the appliance to a power supply of the type described in the operating instructions or as marked on the appliance. 1. Take heed of warnings and instructions You should read all the safety and operating instructions before operating this appliance. [. . . ] There are four speeds for fast playback: x2, x4, x8 and (except for audio CDs) x20. Press the button repeatedly to cycle through the different speeds. To resume normal playback speed, press PLAY. Skipping chapters/tracks To skip chapters (or tracks on a CD), press or . When skipping back, the first button press takes you to the beginning of the current chapter. Pressing the button again takes you to the start of the previous chapter. Note that it is common for Video CDs to have only one track. HDCD indicator This LED is located on the left of the display and lights green to indicate when HDCD (High Definition Compatible Digital) material is playing from suitably recorded audio CDs. Playing a disc Loading a disc Press LOAD on the front panel (or OPEN on the handset) and place the disc on the tray, with the playback side facing down. Some discs are double sided, in which case the side labelled `side A' should face up, to access side A. Press LOAD on the front panel to close the tray. The disc loads after a pause of a few seconds. Pausing playback Press PAUSE on the front panel or on the remote control to pause playback. To resume playback, press PLAY on the front panel or on the handset. Stopping playback Press the STOP button on the front panel or control to stop playback. on the remote Playing a disc Most DVDs begin playing automatically, but some titles begin by displaying a menu. Select the menu item `Play movie' (or similar) using the cursor pad, then press OK to start playback. For CDs and VCDs (and DVDs that do not play automatically), press PLAY. Note that when playing DVDs, the drive mechanism operates at much higher speeds compared to CDs and may produce more noise when loading and playing initial chapters. When playing a DVD, pressing STOP once performs a `resume stop'. If you now press PLAY, playback resumes from the point it was stopped. If you press STOP twice, this is a `complete stop', and playback resumes from the beginning of the disc. DV88 9 Using the CR-314 remote control CD/DVD Ensure that DVD mode is selected using the CD/DVD toggle button. The `DVD' LED above the CD/DVD button is lit briefly when DVD mode is selected. 0­9 keypad This allows direct access to individual tracks on audio CDs. To select a track, press the corresponding keypad button followed by OK. For tracks greater than 9, enter the digits in sequence. For example, to play track 15, press 1, then 5, then OK. DISP (display) Dims or turns the DV88's display on or off. Turning the display off generally gives a slight improvement in sound quality. Pressing DISP once turns the display off; twice dims the display. [. . . ] Enter the `Setup' menu and check the `TV system' setting (see page 7) Enter the `Setup' menu and change the `TV system' setting to `Auto' (see page 7) 1. Select the appropriate input on the audio device (consult that product's handbook) 2. Check connections at both ends and if necessary, try an alternative cable Switch player off, wait thirty seconds and restart No picture 1. Bad video connection from DV88 to TV Picture does not fit screen 1. [. . . ]