User manual ARCAM P35

[. . . ] Cleaning Unplug the unit from the mains supply before cleaning. The case should normally only require a wipe with a soft, damp, lintfree cloth. Do not use paint thinners or other chemical solvents for cleaning. We do not advise the use of furniture cleaning sprays or polishes as they can cause indelible white marks if the unit is subsequently wiped with a damp cloth. [. . . ] the default setting is `Global' which affects all inputs equally. `Per source' allows you to set tone controls for individual inputs: once set, the amplifier remembers tone settings for each input. processor Mode ­ This mode enables you to adjust the gain of the amplifier. The amplifier can then be used to drive the front left and right speakers in a surround sound system when fed from a separate processor. The volume of the entire system can then be controlled using the processor. Feed the sound from the processor into the TAPE input. set the gain to match the amplifiers that drive your other loudspeakers. Welcome message ­ You can change the power on `Welcome message' from `Arcam Amp' to display your name, postcode, etc. When customising the message, use the UP and DOWN buttons to select the cursor position and the Control knob to change the letter. Phono/Aux Text ­ The C30 is fitted with a phono module, so when the phono input is selected as the source, `PHONO' is displayed. Should you wish to remove the phono board, then the AUX connections can be used as a line input. In this case, change the text displayed to `AUX', using this menu option. Restore Settings ­ this restores all amplifier settings, including input trims and the welcome message, to their factory defaults. The default display mode is VOLUME, where the Control knob is used to adjust the sound level. Press SELECT once to enter edit mode, then repeatedly to cycle through the other sound settings: BALANCE, BASS and TREBLE. When a setting is selected (shown on the display), it can be adjusted by using the control knob. Press ENTER to store the change you have made and return to default (volume) mode, or press SELECT again to move to the next setting. It is possible to customise (change to your preference) many of the features of the C30. Press SELECT repeatedly until the display shows `CUSTOMISE->'; Rotate the Control knob to choose which setting you wish to alter; Press SELECT to adjust the chosen setting with the Control knob; Press ENTER to confirm the adjustment, or press SELECT to confirm the adjustment and move on to the next item. Press ENTER twice to leave the Customise menu. CR-389 Remote Control The CR-389 remote control gives access to all functions available on the front panel of the C30. These buttons are used to control tuner functions. [. . . ] Connect the cables as shown in the diagram below, ensuring correct polarity at all times. Boost/cut Power amplifier input Nominal sensitivity Input impedance Gain Preamplifier output Nominal output level Maximum output level Output impedance Headphone output Maximum output level into 600 Output impedance General Mains voltage Power consumption (maximum) Power consumption (standby) Dimensions W x D x H (including feet) Weight (net) Weight (packed) Supplied accessories 700mV 8V RMS <50 5V 4. This means that designs and specifications are subject to change without notice. NOTE: All specification values are typical unless otherwise stated. [. . . ]