User manual ARCAM SOLO MINI

[. . . ] It has been designed in such a way that it does not require a safety connection to electrical earth (`ground' in the U. CAUTION:To reduce the risk of electric shock, do not remove cover (or back). WARNING:To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated `dangerous voltage' within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] In weak signal areas, a high-gain, externally-mounted or roof-mounted aerial is desirable in order to receive the highest number of services. In Band III transmission areas (such as the UK), use a multi-element Yagi aerial with the elements mounted vertically, as the transmissions are vertically polarised. If you are close to more than one transmitter, use an omnidirectional or folded dipole aerial. If the DAB services in your area are transmitted on L-band, then ask your dealer for advice for the best aerial to use. In strong signal areas, the supplied FM wire aerial can be used with reasonable results. connect the supplied aerial to the centre terminal of the Fm coaxial connector input on the rear panel of the unit. Experiment with the position of the aerial to get the best reception. In weak signal areas, or for optimal FM radio reception, a roof- or loft-mounted aerial is advised as this will give superior reception. In some areas, cable radio may be available or, in an apartment building, a distributed aerial system may be installed. In either of these cases you should have sockets in your home marked Fm or VHF (do not use those marked tV); these should be connected to the Fm coaxial connector on the rear of Solo Mini. Make sure that the aerial is positioned well away from Solo Mini itself, TVs, computers and other sources of RF `noise'. Rotate the aerial to discover which position gives the best reception. In weak signal areas, or when Solo Mini is in use inside a steel-framed building (such as an apartment building), a wire between 3 and 5 metres long can be used to strengthen reception. Mount this high up outside the building (if possible) and connect one end of this wire to the `AM' part of AM aerial input, in addition to the loop aerial supplied (do not disconnect the AM loop aerial). Push the tab into the open slot in the base of the stand. Connect the lead wires to the AM socket at the rear of Solo Mini (the wires are not polarised). Disc tracks are played back in sequential order. After the last track has finished, playback restarts from the first track. Playback of the current track is repeated until cancelled. After every track on the CD has been played once, playback restarts from the first track. With Solo Mini switched on (blue light showing), gently insert a CD (label-side up) into the disc slot on the front panel. allow the disc to be drawn in by the motorised rollers. [. . . ] Earlier Set the hours Later Previous Set the day next Power off the unit, using the top panel POwER button, or the remote control 2 button. The light next to the top panel POwER button glows red, showing that the unit is in Clock mode. Press B once to enter the Clock Set screen. Press G to move to the hours; adjust with the BC cursor keys. [. . . ]