User manual ARGUS DC-1088

[. . . ] Sealed vehicles or other places exposed to direct sunlight or subject to extremely temperatures. Do not open the battery cover when the power is on as this may cause a loss of images. If the camera has gotten wet, immediately turn the power OFF and remove the batteries. This camera is a precision electronic device. [. . . ] - OFF mode: the flash does go off. 7 Note: When flash is charging, " " will blink on the LCD display. If the battery is low and the flash is on AUTO or ON mode, the " " will blink on the LCD display and the camera will not take picture. Image Quality HQ HQ or Press the UP/Down button and select LO/HI. Change the mode by pressing Up or Down to make the selection and press the shutter button to confirm. Image Size SXGA or VGA Press the UP/Down button and select the SXGA/VGA. Change the mode by pressing the Up or Down to make the selection and press the shutter button to confirm. 8 Note: When flash is charging, " " will blink on the LCD display. If the battery is low and the flash is on AUTO or ON mode, the " " will blink on the LCD display and the camera will not take picture. Image Quality HQ HQ or Press the UP/Down button and select LO/HI. Change the mode by pressing Up or Down to make the selection and press the shutter button to confirm. Image Size SXGA or VGA Press the UP/Down button and select the SXGA/VGA. Change the mode by pressing the Up or Down to make the selection and press the shutter button to confirm. Camera Mode or or Press the UP/Down button and select Camera mode. Press Up or Down to make the selection and press the shutter button to confirm. 9 is the default mode of the camera. - When the icon is displayed, the camera to take 3 continuous pictures. - When the icon mode is displayed, the camera goes into video mode. Press and hold the shutter button to start recording; release to stop. The picture sequence is stored in AVI-format. Self-Timer Mode or Press the UP/Down button and select mode. Change the mode by pressing Up or Down to make the selection and press the shutter button to confirm. When the display go back to camera mode, press "Shutter button, " the camera will take the picture after 25 beeps (approx. 10 sec delay). Frequency Control or Press the UP/Down button until you see 50H/60H. Change the mode by pressing Up or Down to make the selection and press the shutter button to confirm. 10 Deleting Images or Press the UP/Down button until you see mode. Change the mode by pressing Up or Down to make the selection and press the shutter button to confirm. ONE deletes the last picture taken; ALL deletes all the pictures in the camera. Additional Information - When selecting a mode, a corresponding icon will appear on the LCD display panel. The camera will return to regular mode after 5 seconds of inactivity. - When memory is full, the camera will beep and " " will appear on the LCD display panel. - The battery status indicator: " " The battery is full. [. . . ] The camera driver has to be installed before picture download. Ensure that camera is connected the rear USB port of the computer. Why would I get horizontal, black stripes in photos taken abroad?The camera is set to your country's AC mains frequency (e. g. [. . . ]