User manual ARISTO AM-628LXB

[. . . ] 1 Electronic Emission Notices Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instructions contained in this manual, may cause harmful interference to radio and television communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] The feature is enabled in integrated peripherals menu of CMOS setup. (1) single Key Turn on - if you set a single key password, the system will turn on immediately after you press the password key. (2) Keys Sequence Turn on - if you set a password with more than one character, ie. a combination of keys, the system will turn on after you press the password key sequence and then a <enter>. Please notice that the power button will have no function if the keyboard password power on feature is enabled. JP8, JP23 - BIOS Program Voltage JP8 1-2 1-2 2-3 JP23 1-2 2-3 2-3 Selection INTEL MX ATMEL/SST JP8 & JP23 are pre-installed in the factory. They should NOT be altered by the users. * =Default setting Close Open 8 Installation Installing the Retention Mechanism To install the retention mechanism, follow these steps: 1. Locate Slot 1 and the four attachment studs on the motherboard. To position the mechanism, orient it as shown in figure. The tab on the connector fits into a notch in the base of the mechanism. When properly seated, the base of the mechanism is flush with the motherboard. Studs Retention Mechanism Captive Nuts Slot 1 Tab 3. Finger tighten all four captive nuts to make sure they start correctly on the threads of the attachment studs. To secure the mechanism, tighten the captive nuts. Installing the Processor To install the processor, follow these steps: 1. Insert the processor in the retention mechanism. Press down on the processor until it is firmly seated in the Slot 1 connector and the latches on the processor lock into place. Latches Retention Mechanism Retaining Pins Support Bar 3. Slide the top heatsink support bar onto the retaining pins of the support's base as shown in figure. Setting the Processor Speed After you install the processor and install the motherboard, set the processor speed by CMOS setup. Change the CPU speed as detailed in the manual. Technical Reference Booklet 9 Installing the DIMMs 1. Turn off all peripheral devices connected to the computer. Remove the computer cover and locate the DIMM sockets. Holding the DIMM by the edges, remove it from its antistatic package. Make sure the clips at either end of the socket are pushed away from the socket. Clip DIMM Clip DIMM Socket Notch 5. Align the two small notches in the bottom edge of the DIMM with the keys in the socket. Insert the bottom edge of the DIMM into the socket. When the DIMM is seated, push down on the top edge of the DIMM until the retaining clips at the ends of the socket snap into place. [. . . ] The difference between them are: Supervisor Password : You can enter the Setup Program and change the options of the setup menus. User Password : You can enter the Setup Program but cannot change the options of the setup menus. When you select this function, the following message will appear at the center of the screen to assist you in creating a password. ENTER PASSWORD: Type the password, up to eight characters in length, and press<Enter>. The new password will clear the previously entered password from the CMOS memory. You will be asked to confirm the password. Type the password again and press <Enter>. [. . . ]