Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ARISTO AM-647BX. We hope that this ARISTO AM-647BX user guide will be useful to you.
Lastmanuals help download the user guide ARISTO AM-647BX.
Detailed instructions for use are in the User's Guide.
[. . . ] 1
Electronic Emission Notices
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instructions contained in this manual, may cause harmful interference to radio and television communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Close Open
Technical Reference Booklet
JP29 JP30 JP31
1 1 1
1
JP9
1
JP28
CN22
JP15 1 JP8 1 Selection
Normal* CMOS Clear
1
JP3
Selection
Normal* Clear Keyboard Power On Password
7
JP9 - Keyboard Power Select
JP9
(1-2)* (2-3)
Selection
Powered by +5V Powered by +5V Standby (Allows Keyboard Power On)
Keyboard Password Power On (Only for ATX Power Supply)
This motherboard provides a special security feature of keyboard password power on. The feature is enabled in Integrated Peripherals Menu of CMOS setup. (1) Single Key Turn On - if you set a single key password, the system will turn on immediately after you press the password key. (2) Keys Sequence Turn On - if you set a password with more than one character, ie. a combination of keys, the system will turn on after you press the password key sequence and then a <enter>.
Please notice that the power button will have no function if the keyboard password power on feature is enabled.
JP8, JP15 - BIOS Program Voltage
JP8
(1-2) (1-2) (2-3) (2-3)
JP15
1 1 1 1
Selection
(1-2) (2-3) (2-3) (2-4) INTEL (1MB) MX (1MB) ATMEL/SST (1MB) ATMEL/SST (2MB)
JP8 & JP15 are pre-installed in the factory. They should NOT be altered by the users.
JP29, JP30, JP31 - Sound Chip Enable Setting
JP29, JP30, JP31
1 1 1 1 1
Selection Enable* Disable
(1-2)*
1
(2-3)
* =Default setting
Close
Open
Hardware Setup
8
Memory Configuration
You can install up to 256MB(SDRAM) or 512MB(Registered SDRAM) of memory in the motherboard DIMM sockets. The board has DIMM sockets arranged as banks 1, and 2. You can install DIMMs in any of the two banks, and use different size DIMMs in different banks. The BIOS detects the size and type of installed memory. Turn off all peripheral devices connected to the computer. Remove the computer cover and locate the DIMM sockets. Holding the DIMM by the edges, remove it from its antistatic package. Make sure the clips at either end of the socket are pushed away from the socket.
Clip DIMM
Clip DIMM Socket Notch
5. Align the two small notches in the bottom edge of the DIMM with the keys in the socket. Insert the bottom edge of the DIMM into the socket. When the DIMM is seated, push down on the top edge of the DIMM until the retaining clips at the ends of the socket snap into place. Make sure the clips are firmly in place. If you installed a DIMM with ECC memory, start the computer and use the ECC Configuration feature in Setup to enable the use of ECC.
Caution Please check your computer chassis if it is carrying any metal mounting post at this location.
Remove the mounting post or add insulation to the post before putting in the motherboard.
Technical Reference Booklet
9
Installing the Retention Mechanism for Intel® Pentium® II or Intel® Celeron® Processor
To install the retention mechanism, follow these steps: 1. Locate Slot 1 and the four attachment holes on the motherboard. To position the mechanism, orient it as shown in figure. The tab on the connector fits into a notch in the base of the mechanism. Press down on the studs until it is firmly seated in attachment holes. [. . . ] User Password : You can enter the Setup Program but cannot change the options of the setup menus.
When you select this function, the following message will appear at the center of the screen to assist you in creating a password.
Technical Reference Booklet
15
ENTER PASSWORD: Type the password, up to eight characters in length, and press<Enter>. The new password will clear the previously entered password from the CMOS memory. You will be asked to confirm the password. Type the password again and press <Enter>. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ARISTO AM-647BX
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual ARISTO AM-647BX will begin.