User manual ARISTON ANDRIS

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ARISTON ANDRIS. We hope that this ARISTON ANDRIS user guide will be useful to you.

Lastmanuals help download the user guide ARISTON ANDRIS.


Mode d'emploi ARISTON ANDRIS
Download
Manual abstract: user guide ARISTON ANDRIS

Detailed instructions for use are in the User's Guide.

[. . . ] This manual is an integral part of the product. Keep it with care with the appliance, and hand it on to the next user/owner in case of change of property. Read the instructions and warning in this manual carefully, they contain important information regarding safe installation, use and maintenance. The appliance must be installed and commissioned by a qualified technician in accordance with local legislation and health and safety regulations. [. . . ] This appliance is conforming with the international electrical safety standards IEC 60335-1 and IEC 60335-221. The CE marking of the appliances attests its conformity to the following EC Directives, of which it satisfies the essential requisites: - LVD Low Voltage Directive: EN 60335-1, EN 60335-2-21, EN 60529, EN 62233, EN 50106. CAUTION Observe all general warnings and safety standards listed at the beginning of this text in full; all such instructions are obligatory. The appliance must be installed and commissioned by a qualified technician in accordance with established regulations and local health and safety regulations. We recommend installing the appliance as close as possible to the delivery points to minimise heat loss along the pipes. Local regulations may provide for restrictions on installation in bathrooms; observe any regulatory minimum distances. The range of water heaters includes models set up to be assembled above or below the point of use (sink, basin or shower). The models intended to be assembled under the point of use are called "undersink". To facilitate maintenance, make sure there is a clearance of at least 50 cm inside the enclosure for access to the electrical equipment. Fix the supplied bracket to the wall with screws and dowels of adequate size for the type of wall. Hook the water heater to the bracket and pull down to make sure it is secured. 17 EN HYDRAULIC CONNECTION Hook up the water heater inlet and outlet with pipes or fittings that are resistant to the operating pressure and hot water temperature, which may reach and even exceed 80°C in normal operation. Do not employ materials not rated for such temperatures. Before using the appliance, we recommend filling its tank with water and draining it completely so as to remove any residual impurities. €Gravity drain” connection Specific taps must be used for this type of installation and the connection must be implemented as shown in the diagram in Fig. With this solution, the water heater can work at any mains pressure and no type of tap must be connected on the outlet pipe, which acts as a vent. Electrical connection Before working on the appliance, shut off mains power with its external power switch. Before installing the appliance it is recommended to thoroughly check the electrical system to verify compliance with established regulations; the manufacturer is not liable for damage caused by lack of grounding or anomalous power supply. Check that the mains power supply is rated for the heater's maximum power draw (refer to the nameplate) and that the electrical cables are suitably rated and regulatory. multi-plugs , extensions and adapters may not be used. Do not use the plumbing, heating or gas pipes for grounding the appliance. If the appliance has a power cord which requires replacement, use a cable of equivalent type (H05VV-F 3x1 mm2, dia. [. . . ] Operation, setting the operating temperature Start up Start up the heater with its two-pole switch. In models with no switch, power up by turning the adjustment knob clockwise. The indicator lamp only remains on when heating up. The thermostat will automatically disconnect the resistance when the preset operating temperature is reached. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ARISTON ANDRIS

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual ARISTON ANDRIS will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag