User manual ARTHUR MARTIN AFT629N

[. . . ] The power outlet mus be as secure as possible directly in the junction box. The electrical data is found on the nameplate, after opening the grease collector (11), behind the stainless steel filter (14), in the interior of the device. The connection and commissioning may only be carried out by a professional. Never use the exhaust hood without a filter (7/14) and open grease collector (11). [. . . ] Screw the cable clamp into the mounting and secure with the set screw. Workflow: Now screw the four wire cables with the cable supports onto the hanger bolts. Now the steel cable can get twisted but it will `untwist` during workflow 7. Workflow: The wire cable relaxes and the length of the steel cable can be varied by exerting pressure onto the cable clamp. The hood can be aligned using a water level. Workflow: Fasten the power cord of the hood to the feed line on site. Uncover the hood after installation only so that no dirt particles can reach the top of the hood. The unit can be uncovered again only once the kitchen has been completely set up and the final cleaning has taken place. Make sure that the unit is disconnected from the power supply. 7 Remove protective box from UV-C lamp (13) Insert the stainless steel filter (586x324 mm) (14) into the hood body (1) Please ensure that the filter is correctly inserted!All filters are equipped with a micro switch which interrupts the hood`s electrical circuit power when it is incorrectly positioned!Moisten a soft cloth and apply to unit with light pressure, let dry and then polish in the brushing direction. It is very important to take note of the "brushing direction" when handling stainless steel devices!Interior Cleaning: The unit must be disconnected from the mains before it is opened!When changing the activated carbon or cleaning the metal grease filter (7/14), clean the accessible housing parts of grease deposits. This way, the risk of fire is minimized and optimal function is maintained. With increasing saturation of fatty residues, the risk of fire increases and the function of the unit can be impaired. Remove the activated carbon insert and the thumb screws before cleaning!The metal grease filter (7/14) must be cleaned every 8 to 10 weeks under normal operating conditions (2-3 hours daily) Cleaning should be done with the cleaner which is included with the exhaust hood however the cleaning can be done in the dishwasher depending on the size of the filter. The cleaning intervals for the metal filter (7) on the top side of the hood body are shorter during the heavy pollen season. The inner layers of the metal fat filter (7) are made of aluminum. it resists chemical influences (corrosion resistance). [. . . ] The hood cannot be shut off: Check that all filters have been inserted correctly, that each filter is equipped with a microswitch which will interrupt the electrical circuit when incorrectly positioned. Service The well-trained customer service of Electrolux is available to all of our customers. Before you contact customer service: Make sure that there have not been any errors in operation. Check your exhaust hood according to the chapter "What to do if. [. . . ]