User manual ARTHUR MARTIN ASF65090W

[. . . ] user manual Dishwasher ASF 65090 2 electrolux Electrolux. Thinking of you. Share more of our thinking at www. electrolux. com Contents Safety information Product description Control panel Use of the appliance Setting the water softener Use of dishwasher salt Use of rinse aid Loading cutlery and dishes Use of detergent Multitab function 2 3 4 5 5 7 7 8 10 11 Setting and starting a washing programme 12 Washing programmes 13 Care and cleaning 14 What to do if. . . 16 Technical data 17 Installation 17 Water connection 18 Electrical connection 19 Environment concerns 19 Subject to change without notice Safety information For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. [. . . ] To activate the multitab function: · Press and hold the two multitab buttons (function buttons D and E). To deactivate the multitab function: · Press and hold the two multitab buttons (function buttons D and E). The multitab indicator light goes off. 12 electrolux Do these steps if the drying results are not satisfactory: 1. Fill the rinse aid dispenser with rinse aid. · You can only activate or deactivate the rinse aid dispenser when the multitab function is activated. To activate/deactivate the rinse aid dispenser: 1. Make sure that the appliance is in setting mode. Press and hold function buttons B and C. ­ The indicator lights for function buttons A, B, and C start to flash. ­ The indicator lights for function buttons A and C go off. ­ The indicator light for function button B continues to flash. ­ The digital display shows the setting. Rinse aid dispenser deactivated Rinse aid dispenser activated 6. ­ The digital display shows the new setting. Switch off the appliance to save the operation. Fill the salt container and rinse aid dispenser. Adjust the water hardness setting to the highest level. Adjust the water softener to the water hardness in your area. Adjust the rinse aid dosage. Setting and starting a washing programme Set the washing programme with the door ajar. The washing programme only starts after you close the door. Until then it is possible to modify the settings. Do these steps to set and start a washing programme: 1. Make sure that the appliance is in setting mode. Refer to the chapter 'Washing programmes'. [. . . ] The internal diameter must not be smaller than the diameter of the hose. If you connect the water drain hose to a trap spigot under the sink, remove the plastic membrane (A). If you do not remove the membrane, remaining food can cause a blockage in the drain hose spigot The appliance has a security feature to prevent that dirty water goes back into the appliance. If, the spigot of the sink has a 'non-return valve', this valve can cause the appliance to drain incorrectly. [. . . ]