User manual ARTHUR MARTIN ASL64050

[. . . ] Com Contents Safety information Product description Control panel First use Setting the water softener Use of dishwasher salt Use of rinse aid Daily use Loading cutlery and dishes Use of detergent Multitab function Select and start a washing programme 2 4 5 6 6 7 8 9 10 12 13 14 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. Technical data Hints for test institutes Installation Water connection Electrical connection Environment concerns 15 16 17 18 19 20 21 21 22 22 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Activation/deactivation of the multitab function Simultaneously press and hold the two multitab buttons (function buttons D and E) until the multitab indicator light comes on. To deactivate the function press the same buttons again until the indicator light corresponding to the multitab function symbol goes off. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. The activation/deactivation of the rinse aid is only possible with the multitab function active. Press function button B, the lights of function buttons A and C turn off while the light of function button B continues to flash. The digital display indicates the current setting. rinse aid dispenser deactivated Rinse aid dispenser activated 4. To change the setting, press button B again, the digital display shows the new setting. To memorize the operation, switch off the dishwasher by pressing the on/off button. If you decide to revert back to the use of individual detergents we advise that you: 1. Fill up the salt container and the rinse aid dispenser again. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Select and start a washing programme Select the washing programme and delay start with the door slightly opened. The start of the programme or the countdown of the delay start will occur only after the closure of the door. Until then it is possible to modify the settings 1. Check that the baskets have been loaded correctly and that the spray arms are free to rotate. Press the button corresponding to the required programme (refer to 'Washing programmes' chart). Close the appliance door, the programme starts automatically. Setting and starting the programme with delay start 1. After having selected the washing programme, press the delay start button until the flashing number of hours for the delay start shows in the digital display. [. . . ] Our appliances are supplied with a security device to protect against the return of dirty water back into the machine. If the spigot of your sink has a "no return valve" incorporated this can prevent the correct draining of your dishwasher. To avoid water leakage after installation make sure that the water couplings are tight. Safety standards require the appliance to be earthed. [. . . ]