User manual ARTHUR MARTIN AWT5020W

[. . . ] Programme selector Pushbuttons and their functions Lights of cycle progress "Start/Pause" pushbutton "Delay start" pushbutton 2 3 4 5 12 electrolux Dispenser box Prewash Wash Softener (do not fill above the MAX symbol M ) Safety Information Please read these points carefully before installing and using your appliance. Keep this user manual with your appliance. general safety · Do not modify or attempt to modify this appliance. Ensure that all coins, safety pins, brooches, screws etc have been removed before starting a washing programme. [. . . ] Permanent : Hold down the "Spin" (Essorage) and "Time Manager" pushbuttons for a few seconds. The option is permanently activated, even if the appliance is switched off. "Delay start" (Départ différé) This option allows you to delay the start of a wash programme by 3, 6 or 9 hours by pressing the . "Delay start" pushbutton You can change or cancel the delayed start time at any time before you press the "Start/Pause" pushbutton (Départ/Pause) by pressing the "Delay start" pushbutton again (when all indicators are off, the wash programme will start immediately). If you have already pressed the "Start/Pause" pushbutton (Départ/Pause) and you want to change or cancel the delayed start, proceed as follows : Warning!Before closing the lid of your appliance, ensure that the drum is properly closed : · When the two shutters are closed, · locking button A released. Proportioning of detergents Pour the amount of washing powder into the washing and prewash compartments if you have selected the "prewash" option. The "Start/Pause" (Départ/Pause) pushbutton flashes red for a few seconds. Selecting the spin speed Press the "Spin" pushbutton (Essorage) to change the spin speed, if you want your washing to be spun at a different speed to the one selected by the appliance. you can also select "No spin" , 3). "Rinse hold" or "Night silence plus" The maximum speed is 700 rpm (AWT7020W) or 500 rpm (AWT5020W) for all the programmes. To cancel the delay start and start the cycle immediately, press "Start/Pause" (Départ/Pause) and then "Delay start" . To change the timer delay period, you must go through the "Stop" position and reprogramme your cycle. The lid will be locked during the delayed start time. If you need to open it, you must first pause the appliance by pressing the "Start/Pause" pushbutton (Départ/Pause). After closing the lid again, press the "Start/Pause" pushbutton (Départ/Pause). Start of the programme Press the "Start/Pause" pushbutton (Départ/ Pause) to start the cycle ; the corresponding light will come on green. It is normal for the programme selector to remain stationary during the cycle. The light corresponding to the current cycle is illuminated. Lavage : Wash Rinçage + Essorage : Rinse + Spin Fin : End Interrupting a programme Adding washing during the first 10 minutes Press the "Start/Pause" pushbutton (Départ/ Pause) : the corresponding light will flash green while the appliance is paused. [. . . ] The detergent is unsuitable for machine washing, there is too much washing in the drum, the wash cycle is unsuitable, there isn't enough detergent. You have found water around the washing machine: Wash is unsatisfactory: The appliance vibrates, is noisy: · All packaging have not been removed from the appliance (see installation section), · The appliance isn't level and is unbalanced, · The appliance is too close to the wall or furniture, · washing is unevenly distributed in the drum , · The load is too small. The water inlet filters are dirty, the power or water supply has been cut off, the motor overheating detector has been activated, the water inlet temperature is lower than usual, the foam detection security system has been activated (too much detergent) and the washing machine has begun draining the foam, · The out of balance detector has been activated: an extra phase has been added to distribute washing more evenly in the drum. The wash cycle is much too long: The washing machine stops during a wash cycle: The lid doesn't open at the end of the cycle: The "Start/Pause" pushbutton 2) flashes red 3): The "Start/Pause" pushbutton 2) flashes red 3) : · The drum shutters are open. [. . . ]