User manual ASK PROXIMA C445

[. . . ] >>>>>>> User's Guide English, Deutsch, Español, Français, Italiano, Svensk, Nederlands, Portugués, Declaration of Conformity Manufacturer: InFocus Corporation, 27700B SW Parkway Ave. Wilsonville, Oregon 97070 USA European Office: Strawinskylaan 585, 1077 XX Amsterdam, The Netherlands We declare under our sole responsibility that this projector conform to the following directives and norms: EMC Directive 89/336/EEC, Amended by 93/68/EEC EMC: EN 55022 EN 55024 EN 61000-3-2 EN 61000-3-3 Low Voltage Directive 73/23/EEC, Amended by 93/68/EEC Safety: IEC 60950-1: 1st Edition October, 2003 Canada This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. Agency Approvals UL, CUL, DEMKO-GS Other specific Country Approvals may apply, see please product certification label. InFocus reserves the right to alter product offerings and specifications at any time without notice. Battery Safety Information CAUTION: Risk of explosion if the battery in this projector is replaced with the incorrect type of battery. [. . . ] You can select from Blank, Mute, Aspect Ratio, Source, Auto Image, Freeze, Magnify, Source Info, and Service Info. The Freeze effect allows you to freeze the displayed image. This is useful if you want to make changes on your computer without your audience seeing them. The Startup Logo menu option lets you change the default startup screen to a black, white, blue, or a custom logo screen via Capture New. Two menu options, Power Save and Screen Save, are provided to automatically shut down the projector after several minutes of inactivity or display a blank screen. A Low Power menu option is also available to help lower the projector's fan sound volume. See page 29. · · · · · · · 23 Optimizing video images After the video device is connected properly and the image is on the screen, you can optimize the image using the onscreen menus. For general information on using the menus, see page 25. · · Adjust the Keystone, Contrast, Brightness, Color, or Tint in the Picture menu. Aspect ratio is the ratio of the image width to image height. TV screens are usually 1. 33:1, also known as 4:3. Choose the option that best fits your input source. Select a listed value, or select User and individually adjust the intensity of the red, green, and blue color. See page 28. Customizing the projector You can customize the projector for your specific setup and needs. See page 29 to page 33 for details on these features. · · · · · · · · · For rear projection, turn Rear mode on in the Settings>System menu. For ceiling mounted projection, turn Ceiling mode on in the Settings>System menu. Specify which source the projector checks first for an active signal during power-up. Turn the projector's on-screen display messages on and off. Specify blank screen colors and startup logos. Control your projector using RS232 commands. Customize the projector for your specific installation using optional long or short throw lenses. [. . . ] This product has a lamp which contains a very small amount of mercury. Dispose of it as required by local, state or federal ordinances and regulations. For more information see www. eiae. org. wait 45 minutes lamp cover screw · 34 4 Loosen the three captive screws (marked by the arrows) on the lamp module. loosen the captive screws on lamp module 5 Carefully remove the lamp module by grasping and lifting the handle. Dispose of the lamp in an environmentally proper manner. lamp module handle 6 Install the new lamp module, making sure that it is properly seated, and tighten the three captive screws. 7 Replace the cover over the lamp module by sliding it back into place and tightening the screw. 8 Plug in the power cable, press the power switch then press the Power button to turn the projector back on. Reset the lamp hour timer by navigating to the Settings>Service menu and selecting Reset Lamp Hours. reset lamp hours in Service menu 35 Cleaning the dust filter 1 Turn off the projector and unplug the power cable. [. . . ]