User manual ASK PROXIMA IMPACT WSX

[. . . ] USER GUIDE IMPACT WSX Not the actual front page 801. 130B USG/WSX/AE-B 02. 08. 95 USER GUIDE IMPACT WSX USER GUIDE LCD PANEL 2 USER GUIDE LCD PANEL TABLE OF CONTENTS INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 MAIN FEATURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 SUPPLIED MATERIAL. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 OPTIONAL MATERIAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 7. 1. 2 SET-UP MEMORY The user controlled set-up, that usually is done when the panel is connected to a new computer, is automatically memorized for future use. The set-up information is stored in a non-volatile memory approximately 5 seconds after the last key is pressed. The memory can store 40 different sources/modes. Several sources are predefined, while the remaining are available for customer set-up of sources. See the Technical Data section for compatibility. Custom sources are stored only if their sync pattern differs from any of the previous selections. The panel automatically selects a new memory location. Most settings are stored individually for each mode, including contrast, brightness, tune etc. 7. 1. 3 CONTRAST The contrast of an image is defined as the relation between dark and light colors. An image of high contrast is often regarded as ` hard' as compared , to the ` soft'feeling of a low contrast image. Low contrast is recommended for long term viewing, while high contrast is used to enhance details. Use the CONTR keys on the remote control (RC) to adjust the contrast. The contrast setting is stored individually for each mode. 13 USER GUIDE LCD PANEL 7. 1. 4 BRIGHTNESS The brightness is the amount of white in an image. The brightness is adjusted to the ambient lighting conditions. Usually, a bright, low contrast image is preferred. Use the BRIGHT keys to adjust brightness. The brightness setting is stored individually for each source. 7. 1. 5 TUNE This feature enables a stable image. An unstable image can be seen as sideways instability or ` swimming' Press TUNE until a stable image is . The setting is stored individually for each source. 7. 1. 6 ON/OFF This switch controls the operation of the panel. When switched on, all functions are active. [. . . ] Only peripherals (computer input/output devices, terminals, printers, etc. ) certified to comply with the Class A limits may be attached to a computer that complies with Class A limits. When connecting to a peripheral device, a shielded input/output cable is required to ensure compliance with FCC rules. The shielded cable that must be used is supplied with the equipment. Operation with non-certified peripherals or non-shielded cables is likely to result in interference to radio and TV reception. [. . . ]