User manual ASK PROXIMA IMPRESSION 1280

[. . . ] QUICK SET-UP ENGLISH The following steps will quickly lead you through set-up and adjustments. The sequence numbers refer to the drawing on the rear of the quick set-up. For details, please consult the following chapters. SETTING UP POWER OFF (1) Switch off all equipment before connecting. COMPUTER/ (2) Connect the computer to the COMPUTER input using the GAcable (Graphics Adapter) and applicable computer and monitor adapters if needed. [. . . ] Trackball sensitivity, except for the mouse, is set under OPTIONS in the menu system. Mouse sensitivity is set at your computer as with the standard mouse. This emulates the ` click-and-hold'function of the desktop mouse. Use DRAG instead of RIGHT key when connected to a Macintosh computer. Once the menu is accessed selections are confirmed using ENTER. MEM - - - 19 USER GUIDE SXGA LCD PROJECTOR 8. 2 PROJECTOR KEYBOARD The keypad on the projector gives access to all controls, either directly or through the menu system. ON/OFF CONTRAST BRIGHT VOLUME MENU CURSORS ENTER RESET SOURCE KEY CONTRAST BRIGHT VOLUME ON/OFF RESET SOURCE MENU CURSOR KEYS ENTER FUNCTION Contrast is the ratio between light and dark colors. Brightness (whiteness) of the image can be altered to suit local lighting conditions. Volume of the audio output can be altered to suit local conditions. Switches the projection lamp off, but leaves power on to the rest of the projector. Automatically adjusts the image correctly Toggles between source 1 & 2 Invokes the menu system. The cursor keys are used to navigate in the menu system Emulates the left mouse key. Once the menu is accessed selection are confirmed using ENTER. MEM Yes Yes Yes - - 20 USER GUIDE SXGA LCD PROJECTOR INDICATOR ON/OFF DPMS modes ALARM FUNCTION · NO LIGHT indicates that the unit is completely switched off by the mains switch · GREEN indicates that the unit is operational · YELLOW indicates that the unit is in standby mode (switched off using the remote control or the keypad) · GREEN/YELLOW FLASHING FAST indicates that the projector is in stand by mode (searching for source) with a fast recovery time. · GREEN/YELLOW FLASHING SLOW indicates that the projector is in suspend mode with a power reduction and longer recovery time. · RED indicates lamp lifetime overdue. 21 USER GUIDE SXGA LCD PROJECTOR 8. 3 THE MENU SYSTEM The menu system is designed to gain access to functions not often used, as opposed to frequently used features that are directly available through the remote control and the projector keypad. Press the MENU key to invoke or exit from the menu system. When the menu is active, the trackball is used to navigate between options (and therefore is not available for mouse control etc. The ENTER key is used to activate or deactivate a function. The PROG key may be assigned to any of the menu functions. Toggle functions (like OSD, REAR etc. ) are tagged when active and untagged when not active. Increase/decrease functions (like TUNE and FREQUENCY etc. ) are adjusted using the trackball or keyboard cursor controls. The OSD field (in the lower left corner of the screen) indicates the actual settings. The menu system is toggled on and off with the MENU key. The MENU is also switched off after one minute of inactivity. [. . . ] Government Printing Office, Washington, DC 20402, Stock No. 004-000-00345-4. 46 USER GUIDE SXGA LCD PROJECTOR 18 APPENDIX A SERIAL COMMAND INTERFACE 18. 1 SETTING UP The projector is prepared for serial (RS-232C) control on the MOUSE2 connector. To enable serial control do the following: · · · Select RS232 in the OPTION MENU. Connect the serial (COM) port from the Computer (Host) to the MOUSE2 connector on the projector using the mouse cable and the optional mouse adapter PC (straight), part. [. . . ]