User manual ASK PROXIMA IMPRESSION 8300

[. . . ] QUICK SET UP SVGA DLP PROJECTOR SETTING UP POWER OFF (1) Switch off all equipment before connecting. COMPUTER (2) Connect the computer to the COMPUTER input using the SVGA cable and applicable computer and monitor adapters if needed. VIDEO (3) Connect video, using the AV cable, to the VIDEO and SOUND inputs. MOUSE (4) Connect the mouse cable to the MOUSE connector of the projector. [. . . ] This feature can be used to hide actions on the computer that the audience need not see, such as changes between software packages, or for returning the audience' attention back to the s presenter!MEM Yes BRIGHT Yes VOLUME ON/OFF Yes - RESET COMP 1 COMP 2 VIDEO S-VIDEO MASK PROG MUTE FREEZE Yes No No 18 USER GUIDE SVGA DLP PROJECTOR KEY POINTER SCALE PAN TRACKBALL RIGHT DRAG LEFT/ ENTER FUNCTION Applies a trackball controlled pointer to the screen. Selects between direct 1:1 mapping or scaling of images. Allows panning within oversized images using the trackball. The trackball is mainly used to control the mouse pointer (if the mouse cable is attached properly). When SCALE, MASK, PAN or MENU is invoked, mouse control is disabled, as the trackball is used to control these functions instead. Trackball sensitivity, except for the mouse, is set under OPTIONS in the menu system. Mouse sensitivity is set at your computer as with the standard mouse. This emulates the ` click-and-hold'function of the desktop mouse. Use DRAG instead of RIGHT key when connected to a Macintosh computer. Once the menu is accessed selection are confirmed using ENTER. MEM No No - - - 19 USER GUIDE SVGA DLP PROJECTOR 8. 2 PROJECTOR KEYBOARD The keypad on the projector gives access to all controls, either directly or through the menu system. ON/OFF CONTRAST BRIGHT VOLUME MENU CURSORS ENTER ZOOM FOCUS ALARM RESET SOURCE The following table describes each key in detail. For details on CONTR, BRIGHT, VOLUME & MENU see the remote control section above. KEY ZOOM FOCUS SOURCE CURSOR KEYS ENTER FUNCTION Zoom is used to obtain the desired screen size of the image. Focus is adjusted until the image (pixels) becomes sharp on the screen. Toggles between computer 1, computer 2, S-video and video as the active source The cursor keys are used to navigate in the menu system Emulates the left mouse key. Once the menu is accessed selection are confirmed using ENTER. MEM - 20 USER GUIDE SVGA DLP PROJECTOR INDICATOR ON/OFF ALARM FUNCTION · NO LIGHT indicates that the unit is completely switched off by the mains switch · GREEN indicates that the unit is operational · YELLOW indicates that the unit is in standby mode (switched off using the remote control or the keypad) · RED indicates lamp lifetime overdue. 8. 3 THE MENU SYSTEM The menu system is designed to gain access to functions not often used, as opposed to frequently used features that are directly available through the remote control and the projector keypad. Press the MENU key to invoke or exit from the menu system. When the menu is active, the trackball is used to navigate between options (and therefore is not available for mouse control etc. The ENTER (left) key is used to activate or deactivate a function. The PROG key may be assigned to any of the menu functions. Toggle functions (like OSD, REAR etc) are tagged when active and untagged when not active. [. . . ] 3 at delivery (+ 1 per 1000 hours of operation) 14 - 150 MHz 14 - 100 kHz 50 - 120 Hz M, 4. 43 NTSC B, G, H, D, I B, G, H, D, I, K1, L 0 - 1 Vpp 0 - 1 Vpp 0 - 1 Vpp 1V RMS 2 x 5 Watt · CE · UL · cUL · FCC Class A, Subpart J, Part 15 PROJECTOR DIMENSIONS PROJECTOR WEIGHT PROJECTION LENS ANTI-KEYSTONE CORRECTION PROJECTION LAMP IMAGE SIZE (DIAGONAL) PROJECTION DISTANCE DISPLAY COLOR RESOLUTION CONTRAST RATIO PIXEL RESOLUTION DEFECTIVE PIXELS VIDEO FREQUENCY HORIZONTAL SYNC VERTICAL SYNC NTSC SYSTEM PAL SYSTEM SECAM SYSTEM COMPUTER INPUT VIDEO INPUT S-VIDEO INPUT AUDIO INPUTS SPEAKERS APPROVALS 40 USER GUIDE SVGA DLP PROJECTOR 14. 3 POWER SUPPLY 100 - 120 VAC (8A), 60 Hz 220 - 240 VAC (4A), 50 Hz DUAL VOLTAGE 14. 4 REMOTE CONTROL 190 x 49 x 21 mm / 7. 5 x 1. 9 x 0. 8 inches 154 g / 5. 4 ounces (with batteries) 4 pcs LR03/AM4 1. 5V 15 m/45 ft Microsoft 2-key serial mouse; IBM PS/2; MAC CE, FCC Class A UNIT SIZE UNIT WEIGHT BATTERIES FUNCTIONAL RANGE COMPATIBILITY APPROVALS 14. 5 COMPATIBILITY The projector is compatible with the interfaces and resolutions shown below, some of which are predefined. However since different varieties of these exist, a frequency adjustment may be needed. MODE Generic RESOLUTION 640 x 350 640 x 400 640 x 480 720 x 480 800 x 600 1024 x 768 (compressed) 1152 x 870 (compressed) 800 x 600 1024 x 768 (compressed) 640 x 480 832 x 624* 1024 x 768 (compressed) 1152 x 870 (compressed) MAXIMUM VERTICAL FREQUENCY (Hz) 85 85 120 85 120 100 90 120 100 120 120 100 90 SVGA XGA MAC * MAC 832x624 mode is projected at 800 x 600 resolution and therefore a few lines vertically and horizontally at the edge of the MAC images at 832 x 624 will not be visible. The image is not compressed and cannot be panned around using the remote control. 41 USER GUIDE SVGA DLP PROJECTOR 14. 6 PROJECTION DISTANCES The following table shows the combinations of projection distances and screen sizes that are possible. MINIMUM WIDE DISTANCE DIAGONAL WIDTH HEIGHT MAXIMUM 3. 00m/ 118" 2. 59m/ 102" 2. 07m/ 81" 1. 57m/ 62" 3. 00m/ 118" 1. 72m/ 68" 1. 37m/ 55" 1. 03m/ 41" 5. 00m/ 197" 4. 28m/ 169" 3. 43m/ 135" 2. 57m/ 101" 5. 00m/ 197" 2. 84m/ 112" 2. 27m/ 89" 1. 71m/ 67" 7. 50m/ 295" 6. 35m/ 250" 5. 08m/ 200" 3. 81m/ 150" 7. 50m/ 295" 4. 21m/ 166" 3. 37m/ 133" 2. 53m/ 100" 1. 17m/ 1. 04m/ 0. 83m/ 0. 63m/ 1. 02m/ 0. 60m/ 0. 48m/ 0. 37m/ 46" 41" 33" 25" 40" 24" 19" 15" TELE DISTANCE DIAGONAL WIDTH HEIGHT Please consider the values given as nominal, with a variation of +/- 10 %. 42 USER GUIDE SVGA DLP PROJECTOR 15 CONNECTORS The connector ports for the source equipment on the projector are located on the right hand-side (when facing) of the unit. [. . . ]