User manual ASK PROXIMA IMPRESSION A4

[. . . ] QUICK SET-UP ENGLISH The following steps will quickly lead you through set-up and adjustments. The sequence numbers refer to the drawing on the rear of the quick set-up. For details, please consult the following chapters. SETTING UP POWER OFF (1) Switch off all equipment before connecting. COMPUTER (2) Connect the computer to the COMPUTER input using the GA (Graphics Adapter) cable and applicable computer and monitor adapters if needed. [. . . ] The trackball is mainly used to control the mouse pointer (if the mouse cable is attached properly). When SCALE, MASK, PAN or MENU 17 MEM Yes Yes Yes - RESET MASK PROG MUTE FREEZE Yes No No SOURCE 1&2 POINTER SCALE PAN LIGHT MENU TRACKBALL No No No - USER GUIDE SVGA LCD PROJECTOR KEY RIGHT BOTTOM/ DRAG LEFT/ ENTER FUNCTION is invoked, mouse control is disabled, as the trackball is used to control these functions instead. Trackball sensitivity, except for the mouse, is set under OPTIONS in the menu system. Mouse sensitivity is set at your computer as with the standard mouse. This emulates the ` click-and-hold'function of the desktop mouse. Use DRAG instead of RIGHT key when connected to a Macintosh computer. Once the menu is accessed selections are confirmed using ENTER. MEM - - 18 USER GUIDE SVGA LCD PROJECTOR 8. 2 PROJECTOR KEYBOARD The keypad on the projector gives access to all controls, either directly or through the menu system. ON/OFF CONTRAST BRIGHT VOLUME MENU CURSORS ENTER ALARM RESET SOURCE KEY CONTRAST BRIGHT VOLUME ON/OFF RESET SOURCE MENU CURSOR KEYS ENTER FUNCTION Contrast is the ratio between light and dark colors. Brightness (whiteness) of the image can be altered to suit local lighting conditions. Volume of the audio output can be altered to suit local conditions. Switches the projection lamp off, but leaves power on to the rest of the projector. Automatically adjusts the image correctly Toggles between source 1 & 2 Invokes the menu system. The cursor keys are used to navigate in the menu system Emulates the left mouse key. Once the menu is accessed selection are confirmed using ENTER. MEM Yes Yes Yes - - 19 USER GUIDE SVGA LCD PROJECTOR INDICATOR ON/OFF DPMS modes ALARM FUNCTION · NO LIGHT indicates that the unit is completely switched off by the mains switch · GREEN indicates that the unit is operational · YELLOW indicates that the unit is in standby mode (switched off using the remote control or the keypad) · GREEN/YELLOW FLASHING FAST indicates that the projector is in stand by mode (searching for source) with a fast recovery time. · GREEN/YELLOW FLASHING SLOW indicates that the projector is in suspend mode with a power reduction and longer recovery time. · RED indicates lamp lifetime overdue. 20 USER GUIDE SVGA LCD PROJECTOR 8. 3 THE MENU SYSTEM The menu system is designed to gain access to functions not often used, as opposed to frequently used features that are directly available through the remote control and the projector keypad. Press the MENU key to invoke or exit from the menu system. When the menu is active, the trackball is used to navigate between options (and therefore is not available for mouse control etc. The ENTER key is used to activate or deactivate a function. The PROG key may be assigned to any of the menu functions. Toggle functions (like OSD, REAR etc) are tagged when active and untagged when not active. Increase/decrease functions (like TUNE and FREQUENCY etc) are adjusted using the trackball or keyboard cursor controls. The OSD field (in the lower left corner of the screen) indicates the actual settings. [. . . ] Should condensation appear, leave the projector unit in a controlled environment within the operating limits until the condensation has evaporated before using the projector. 39 USER GUIDE SVGA LCD PROJECTOR 14. 2 PROJECTOR UNIT PROJECTOR DIMENSIONS (H x W x L) PROJECTOR WEIGHT PROJECTION LENS 137 x 249 x 295 (375) mm / 5. 4 x 9. 8 x 11. 6 (14. 7) inch 5 kg / 11 lbs Manual zoom and focus lens 1. 3 zoom ratio f 45-59 mm F 2. 5-2. 9 0. 76 - 7. 6 m / 30 - 300 inches (wide) 0. 58 - 5. 5 m / 23 - 230 inches (tele) 1 - 10 m / 3. 3 - 33 ft 12 degrees 150 W metal halide 750 ANSI lumen 1. 3"polysilicon TFT LCD 16. 7 million 300:1 800 x 600 x 3 10 (max) 12 - 150 MHz 15 - 100 kHz 43. 5 - 130 Hz 0 - 1 Vpp 1V RMS 2 x 1 W, four speakers · CE · UL · cUL · FCC Class A, Subpart J, Part 15 IMAGE SIZE PROJECTION DISTANCE ANTI-KEYSTONE CORRECTION PROJECTION LAMP LIGHT OUTPUT CELL COLOR RESOLUTION CONTRAST RATIO PIXEL RESOLUTION DEFECTIVE PIXELS VIDEO FREQUENCY HORIZONTAL SYNC VERTICAL SYNC COMPUTER INPUT AUDIO INPUT SPEAKERS APPROVALS 14. 3 POWER SUPPLY DUAL VOLTAGE 100 - 120 VAC, 60 Hz, +/- 10 % 220 - 240 VAC, 50 Hz, +/- 10 % 250 W operating, 15W standby 40 USER GUIDE SVGA LCD PROJECTOR 14. 4 REMOTE CONTROL UNIT SIZE (H x W x L) UNIT WEIGHT BATTERIES FUNCTIONAL RANGE COMPATIBILITY APPROVALS 20 x 50 x 190 mm / 0. 78 x 1. 97 x 7. 48 inch 146 g / 0. 32 lb. (with batteries) 4 pcs LR03/AAA 1. 5V penlight 15 m / 50 ft Microsoft 2-key serial; MAC; PS/2 CE, FCC Class A 14. 5 COMPATIBILITY The projector is compatible with the interfaces and resolutions shown below, some of which are predefined. However since different varieties of these exist, a frequency adjustment may be needed. MODE Generic RESOLUTION 640 x 350 640 x 400 640 x 480 720 x 480 800 x 600 1024 x 768 (compressed) 640 x 350 640 x 400 640 x 480 720 x 400 800 x 600 1024 x 768 (compressed) 640 x 480 832 x 624 1024 x 768 (compressed) 1152 x 870 (compressed) VGA SVGA XGA MAC 41 USER GUIDE SVGA LCD PROJECTOR 14. 6 PROJECTION DISTANCES The following table shows the combinations of projection distances and screen sizes that are possible. MINIMUM WIDE DISTANCE DIAGONAL WIDTH HEIGHT MAXIMUM 3. 00m/ 118" 2. 30m/ 91" 1. 84m/ 72" 1. 38m/ 54" 3. 00m/ 118" 1. 80m/ 71" 1. 44m/ 57" 1. 08m/ 43" 7. 00m/ 276" 5. 50m/ 217" 4. 40m/ 173" 3. 30m/ 130" 7. 00m/ 276" 4. 20m/ 165" 3. 36m/ 132" 2. 52m/ 99" 9. 00m/ 354" 7. 00m/ 276" 5. 60m/ 220" 4. 20m/ 165" 9. 00m/ 354" 5. 40m/ 213" 4. 32m/ 170" 3. 24m/ 128" 1. 00m/ 0. 80m/ 0. 64m/ 0. 48m/ 1. 00m/ 0. 60m/ 0. 48m/ 0. 36m/ 39" 31" 25" 18" 39" 24" 19" 14" TELE DISTANCE DIAGONAL WIDTH HEIGHT Please consider the values given as nominal, with a variation of +/- 10 %. 42 USER GUIDE SVGA LCD PROJECTOR 15 CONNECTORS The connector ports for the source equipment on the projector are located on the right hand-side (when facing) of the unit. [. . . ]