User manual ASKO D3122 QUICK START GUIDE

[. . . ] To select a wash program or option, simply press the appropriate button. After you have selected the desired wash program and options, press Start/Stop. Power button (on the top side of the control panel) Program button Program indicator lights Start/Stop button Temperature button Drying button Program progression indicator lights PROGRAMS To select a program, simply press the program button until the indicator light behind the desired program glows. The programs are described below: Heavy Wash (160° F or 130° F) For the heaviest soiled loads, such as pots, pans, casseroles, etc. Normal Wash (150° F or 130° F) For normally soiled loads, such as plates, glasses, bowls, and lightly soiled pans, use the Normal wash program with normal temperature and normal drying . To save more water and energy use economy temperature and economy drying. [. . . ] (Make sure the door is securely closed. ) The indicator light around the button will glow progressively as the program goes through each cycle. When the program is complete, the lights will glow all the way around the button. QUICK START PROCEDURES STAR PROCEDURES ART Refer to this page in the Use & Care Guide. 1. Simply scrape off large food particles before you load the dishware. ) 2. After you've pushed the baskets back inside the unit, manually rotate the upper and lower spray arms to be sure they turn freely. Rearrange any item that blocks the wash arms. Add 1 to 3 tablespoons of automatic dishwashing detergent and close the dispenser cover. (See "Dishwashing Detergent" below. ) 4. Make sure there is rinse aid in the dispenser. Press the main power button on the top left side of the inner door panel to turn on power to the machine. Set the Temperature and Drying options as desired. The dishwasher will start. 3, 4 3 5 6 INTERRUPTING PROGRAM INTERRUPTING A PROGRAM TO ADD AN ITEM If you want to interrupt a program to add an item, open the door slightly until the spray arms stop turning. You can then open the door fully and place the item into the dishwasher. The program will continue from where it was interrupted. Be extremely careful when opening the door during a program. The water is hot and you could get scalded. CHANGING OR STOPPING A PROGRAM If you decide to change the program after you have started the machine, press the Start/Stop button for three seconds. You will have to select the program and options again when you are ready to restart the program. (Note: If the program has already gone through the wash cycle, you will have to add detergent. ) DISHWASHING DETERGENT We recommend that you use only unscented, granular automatic dishwashing detergent. Generally, one tablespoon of detergent is needed for a normal wash load. [. . . ] If this doesn't resolve the problem, call the ASKO Advisory Center. You may be using too much detergent or washing your dishes in water that is too hot. Try using less detergent and a lower temperature setting. It's normal to have some water left in the sump area near the drain. [. . . ]