User manual ASROCK ZH77 PRO3

[. . . ] With respect to the contents of this manual, ASRock does not provide warranty of any kind, either expressed or implied, including but not limited to the implied warranties or conditions of merchantability or fitness for a particular purpose. In no event shall ASRock, its directors, officers, employees, or agents be liable for any indirect, special, incidental, or consequential damages (including damages for loss of profits, loss of business, loss of data, interruption of business and the like), even if ASRock has been advised of the possibility of such damages arising from any defect or error in the manual or product. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CALIFORNIA, USA ONLY The Lithium battery adopted on this motherboard contains Perchlorate, a toxic substance controlled in Perchlorate Best Management Practices (BMP) regulations passed by the California Legislature. [. . . ] Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! Serial ATA2 Connectors (SATA2_2: see p. 13, No. 17) Serial ATA3 Connectors (SATA3_0: see p. 13, No. 16) Serial ATA (SATA) Data Cable (Optional) USB 2. 0 Headers (9-pin USB4_5) (see p. 13, No. 22) (9-pin USB6_7) (see p. 13, No. 23) SATA2_2 SATA2_3 SATA2_4 SATA2_5 These four Serial ATA2 (SATA2) connectors support SATA data cables for internal storage devices. The current SATA2 interface allows up to 3. 0 Gb/s data transfer rate. These two Serial ATA3 (SATA3) connectors support SATA data cables for internal storage devices. The current SATA3 interface allows up to 6. 0 Gb/s data transfer rate. Either end of the SATA data cable can be connected to the SATA / SATA2 / SATA3 hard disk or the SATA2 / SATA3 connector on this motherboard. Besides four default USB 2. 0 ports on the I/O panel, there are three USB 2. 0 headers on this motherboard. PLED (System Power LED): Connect to the power status indicator on the chassis front panel. The LED is on when the system is operating. The LED keeps blinking when the system is in S1/S3 sleep state. The LED is off when the system is in S4 sleep state or powered off (S5). HDLED (Hard Drive Activity LED): Connect to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data. The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assign-ments are matched correctly. Chassis Speaker Header (4-pin SPEAKER 1) (see p. 13, No. 18) Please connect the chassis speaker to this header. 34 Power LED Header (3-pin PLED1) (see p. 13, No. 19) Please connect the chassis power LED to this header to indicate system power status. [. . . ] Insert your Windows® VistaTM 64-bit / 7 64-bit installation disc to the optical drive. Press <F11> to launch boot menu at system POST and choose the item “UEFI:xxx“ to boot. When you see “Where do you want to install Windows?” page, please click “Load Driver”. D. Plug the USB flash disk into your USB port; select “Browse” to find the RAID driver. [. . . ]