User manual ASUS AAM6030BI

[. . . ] AAM6030BI CPE User Manual AAM6030BI User Manual Rev. 20, 2004 AAM6030BI User Manual Table of Contents Introduction 1. 1 Features & System Requirements 2. Your CPE at a glance 2. 1 Ports and buttons (Back panel) 2. 2 LED description (Front panel) 2. 3 LED table & parts list 3. Getting Start 3. 1 Connecting the Hardware 3. 1. 1 Connect the ADSL line 3. 1. 2 Connect the computers or a LAN 3. 1. 3 Attach the power adapter 3. 1. 4 Turn on your computer 3. 2 Configuring Your PC 3. 2. 1 Windows XP: 3. 2. 2 Windows 2000: 3. 2. 3 Windows Me: 3. 2. 4 Windows 95, 98: 3. 2. 5 Windows NT 4. 0: 3. 2. 6 Assigning IP to your PC automatically by DHCP 4. [. . . ] To make the change permanent you need to click on Tools (at the top of the page) and select System Commands. At the system commands page, click on Save All. 4. 5. 2 Changing the CPEs IP address You can change the CPE's IP address by going to the Home screen, click setup and under LAN Setup, select Management. This will bring up the screen shown in Figure 11. 4. 5. 2. 1 Static IP address assignment Your CPE's default IP address and subnet mask are 192. 168. 1. 1/255. 255. 255. 0; this subnet mask will allow the CPE to support 254 users. If you want to support a larger number of users you can change the subnet mask; but remember. The DHCP server is defaulted to only give out 255 IP addresses. Further remember that if you change your CPEs' IP address and you have DHCP enabled, the DHCP configuration must reside within the same subnet The default CPE is the routing device used to forward all traffic that is not addressed to a station within the local subnet. Your ISP will provide you with the default CPE Address. Figure 11 shows a default CPE address of 192. 168. 1. 1 because this was the default CPE defined when the CLIP connection was configured. The hostname can be any alphanumeric word that does not contain spaces. The domain name is used to in conjunction with the host name to uniquely identify the CPE. To access the CPE's web pages the user can type 192. 168. 1. 1 (the CPE's default IP address) or type mygateway. 21 21 AAM6030BI User Manual Figure 11 (Management IP address) The apply button will temporarily save this connection. To make the change permanent you need to click on Tools (at the top of the page) and select System Commands. At the system commands page, click on Save All. 4. 5. 3 Firewall/NAT Services You can enable or disable Firewall and NAT by going to the Home screen, click setup and under LAN Setup, select Firewall/NAT Services. By unselecting the "Enable Firewall and NAT Services" button the firewall and NAT services is disabled for all WAN connections. The apply button will temporarily save this connection. To make the change permanent you need to click on Tools (at the top of the page) and select System Commands. At the system commands page, click on Save All. 4. 6 Advanced The CPE supports a host of advanced features. For basic router functionality, the user does not need to utilize these advanced features. [. . . ] Some games, and some specialty applications have a bit of trouble. The router contains special functionality to handle the vast majority of these troublesome programs and games. NAT does cause problems when you want to run a SERVER though. When running a server, please see the DMZ section below. [. . . ]