User manual ASUS AP160R-S

[. . . ] AP160R-S Pentium 4 1U Rackmount Server ® User Guide Disclaimer/Copyrights No part of this manual, including the products and software described in it, may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means, except documentation kept by the purchaser for backup purposes, without the express written permission of ASUSTeK COMPUTER INC. ASUS PROVIDES THIS MANUAL "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OR CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL ASUS, ITS DIRECTORS, OFFICERS, EMPLOYEES OR AGENTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES (INCLUDING DAMAGES FOR LOSS OF PROFITS, LOSS OF BUSINESS, LOSS OF USE OR DATA, INTERRUPTION OF BUSINESS AND THE LIKE), EVEN IF ASUS HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES ARISING FROM ANY DEFECT OR ERROR IN THIS MANUAL OR PRODUCT. Product warranty or service will not be extended if: (1) the product is repaired, modified or altered, unless such repair, modification of alteration is authorized in writing by ASUS; or (2) the serial number of the product is defaced or missing. [. . . ] LAN Chipsets: The Intel® 82544GC Gigabit Ethernet controller is an integrated Ethernet LAN component that supports 1000Mbps, 100Mbps, and 10Mbps data rates. The Intel 82550 Fast Ethernet controller fully supports 10BASE-T/100BASE-TX networking protocols. SCSI Chipset: The LSI® 53C1010R SCSI controller supports up to 30 Ultra-160 SCSI devices through the onboard dual-channel SCSI connectors. VGA Chipset: The ATI® Rage-XL PCI-based VGA controller supports up to 8MB PC-100 display SDRAM for 1280x1024 and true color resolutions. Storage: Four 1" height, 3. 5-inch width HDD drive bays Expansion: Two full-length 64-bit 133/100MHz PCI-X slots on a proprietary riser card. Power Supply: 115Vac/230Vac 284-watt auto-switching power supply · · · · · · 14 Chapter 1: System Overview The front panel of the server allows easy access to the hard disk drives. The power and reset buttons, LED indicators, and the 68-pin connector for the Combo module are also located on the front panel. The server rear panel includes the connectors, the system devices, and two slots for expansion cards. Power button Power LED Location Switch Location LED Reset button Message LED Location LED Location switch USB ports Very High-density SCSI connector (VHDCI) Combo module rail hole VGA port 1. 2 Front Panel Features 1. 3 Rear Panel Features 68-pin combo drive cage connector Front USB connector Gigabit LAN port 100/10Mbps LAN port PS/2 keyboard port PS/2 mouse port Rear fan Combo module rail hole Power supply fan LAN LEDs HDD access LED HDD power LEDs AC Power socket Power supply fan ASUS AP160R-S 1U Rackmount Server LAN port ( for Server Management) Serial port (COM1) 15 1. 4 Internal Features The standard components inside the AP160R-S server include the motherboard, backplane, bridge board, fans and fan modules, PCI riser card assembly, and power supply. The pictures below show the standard components of the server. 1 11 12 11 10 9 6 1 5 7 2 8 4 3 1. 6. HDD bays Backplane (underneath) Bridge board 1 x 40mm PCI fan 8 x 40mm System fan 1 x 40mm PSU fan 7. 284W PSU NOTE The PCI riser card and card bracket assembly is not shown installed in the above picture. Refer to section "2. 7 Installing a PCI card" for more details on the riser card. 16 Chapter 1: System Overview Chapter 2 This chapter describes the hardware setup procedures that you have to perform when installing system components. ASUS AP160R-S 1U Rackmount Server Hardware Setup 17 2. 1 Removing and installing the chassis cover Removing the cover 1. To release the cover, push the two latches outward, then slide the cover towards the rear for about half an inch. Lift the cover from the chassis. Installing the cover 1. Place the cover on top of the chassis leaving about half an inch gap from the front edge. Half-inch gap 2. Firmly hold down the cover and you slide it towards the front until it fits in place. 18 Chapter 2: Hardware Setup 2. 2 Motherboard Placement NOTE The motherboard and other internal components of the AP160RS server are already installed as indicated in section "1. 4 Internal Features". Refer to the motherboard user's manual for detailed technical information about the motherboard. Placement Direction When installing the motherboard, make sure that you place it into the chassis correctly. The edge with the external ports goes to the rear part of the chassis. Place this side towards the rear of the chassis NOTE You must remove the protruding screws (indicated by black circles above) on the serial port, VGA port, and high-density SCSI connector before installing or removing the motherboard. Otherwise, you cannot properly install or remove the motherboard. Motherboard Screws Place seven (7) screws in the holes indicated by circles to secure the motherboard to the chassis. Doing so may damage the motherboard. ASUS AP160R-S 1U Rackmount Server 19 2. 3 Installing a CPU The 478-pin Zero Insertion Force (ZIF) socket on the NR-LSR motherboard supports an Intel Pentium 4 processor. This section tells you how to install a CPU. Refer to the motherboard user guide for more information. CPU Socket Location Locate the 478-pin CPU socket and note the Pin 1 location. Pin 1 CPU Orientation A CPU has a mark (usually a notch or a gold mark) on one corner to help you identify the correct orientation when inserting it to the socket. Match the marked corner of the CPU to Pin 1 on the socket. Gold Mark CAUTION Incorrect installation of the CPU into the socket may bend the pins and severely damage the CPU! 20 Chapter 2: Hardware Setup Unlock the CPU Socket Unlock the socket by pressing the lever sideways then lifting it up to a 90°-100° angle. Socket Lever 90 - 100 Insert the CPU 1. [. . . ] Refer to the previous sections for instructions on removing system components. 1. Remove the screw that secures the power supply to the chassis base. 2. Remove the screw that secures the power supply to the rear panel. 3. Carefully lift the power supply from the chassis. 38 Chapter 3: Powering Up Appendix A This appendix gives information on the 284W switching power supply that comes with the AP160R-S server. ASUS AP160R-S 1U Rackmount Server Power Supply 39 A. 1 General Description The server comes with an SSI-type 284W ATX power supply with universal AC input that includes PFC and ATX-compliant output cables and connectors. [. . . ]