User manual ASUS APPOLO

[. . . ] Apollo User's Guide 47-060023-005 47-060023-005 Table of Contents Congratulations!. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Step 1 ­ Know Your PC's Operating System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Step 2 ­ Determine Your Connection Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] After your PC has rebooted, right-click on the Diagnostic Tool Icon (see Appendix), and select the Configuration option. 2. When the Configuration window appears, scroll through the PVC setup section to locate the service you will be connecting to. Then click Set As Active. 3. In the Select ADSL Mode section, select the mode(s) recommended by you ADSL service provider. When you have set both the PVC Setup and ADSL Mode, click Close. 4. NOTE: To modify, add, or remove ISP settings from the Configuration window, in the PVC Setup section, click on the PVC Table button. The PVC Table window then appears for the Protocol you are using. Apollo ADSL Modem 31 47-060023-005 5. The PVC Setup window appears. Click Yes to restart your PC system and to allow the new changes to take effect. 6. You must now make an ADSL connection, proceed to the section for the protocol you are using as follows: RFC1483 or RFC1577 RFC2364 or RFC2516 Go to page 33. Go to page 35. Apollo ADSL Modem 32 47-060023-005 Making an ADSL Connection - RFC1483 or RFC1577 1. Right ­ click My Network Places and select Properties. 2. The Network and Dial-up Connections window appears. Right-click on the Local Area Connection, and then click on Properties. 3. The Local Area Connection Properties window appears. Click on Internet Protocol (TCP/IP), then click on Properties. Apollo ADSL Modem 33 47-060023-005 4. The Internet Protocol (TCP/IP) Properties window appears. Under the General tab, enable Use the following IP address. The default settings for IP configurations will turn from gray to white. Enter in the IP address, Subnet Mask, and Default Gateway supplied by your ADSL service provider. Click OK. 5. The previous General Tab window appears. Click OK. 6. The Network and Dial-up Connections window appears. Close this window and your connection is complete. Congratulations, you are done. Your ADSL Internet connection is established! Apollo ADSL Modem 34 47-060023-005 Making an ADSL Connection - RFC2364 or RFC2516 1. Double-click on the ADSL Connect icon that appears on your desktop. ADSL Connect 2. The Connect My connection window will appear. Enter your User Name, Password and Phone Number supplied by your ADSL service provider. You are now ready to make a network connection. Click Dial. 3. The Connection complete window appears, click OK. Congratulations, you are done. Your ADSL connection is established! Apollo ADSL Modem 35 47-060023-005 Windows XP After installing the ADSL modem card, plug the power cable back into the PC system and turn the power on. Insert the ADSL Driver CD-ROM into your system's CD drive now 1. [. . . ] Such use of any trademark does not give you any rights of ownership in that trademark. Except as stated above, this Agreement does not grant you any intellectual property rights in the Software. You agree not to modify, adapt, translate, reverse engineer, de-compile, disassemble or otherwise attempt to discover the source code of the Software. The Software is being delivered to you AS IS and ITeX makes no warranty as to its use or performance. [. . . ]