User manual ASUS BM5620

[. . . ] Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This class B digital apparatus complies with Canadian ICES-003. Observe the following precautions before installing and using the ASUS BM5620 Do not place this device in an unstable position, or on vibrating surfaces. [. . . ] Conventions used in this guide To make sure that you perform certain tasks properly, take note of the following symbols used throughout this manual. WARNING/DANGER: Information to prevent injury to yourself when trying to complete a task. CAUTION: Information to prevent damage to the components when trying to complete a task. IMPORTANT: Information that you MUST follow to complete a task. Upon opening your ASUS BM5620 drive package, check if all the following items are present and in good condition. If any of the items is damaged or missing, contact your retailer immediately. ASUS BM5620 DVD-ROM Drive Audio cable Mounting screw package DVD-ROM driver disc User Manual (English) with 12-Language Quick Installation Guide DVD playback software CD The above items are available in retail boxes only. To ensure proper installation and use of this device, read the instructions and other important information contained in this manual. Emergency Eject Pinhole In cases when you cannot eject a disc from the drive using the eject button due to power failure or software problems, insert a pin or a paper clip into this hole to manually eject the tray and the disc. Make sure the power of the drive is turned off and wait more than one minute till the disc rotation is stopped. Open the loading tray by pressing the Eject Button, then place a CD or DVD with the label side up. If your computer has a sound card or an onboard audio feature, connect an audio interface cable to the 4-pin analog audio connector on the rear of the drive. Connect the other end of the audio cable to the connector on the sound card or on the 4-pin CD connector on the motherboard. All the cable plugs are slotted so that they fit in only one orientation. If a plug does not fit in completely, try reversing it. DO NOT apply too much force when fitting the cable plugs. Replace the computer cover according to your computer manual. When the drive tray ejects out of the drive, place the disc on the tray with the label (printed) side up. If you are using a 12-cm disc, place it on the tray making sure that it fits the outer circular border. this border helps hold the disc in place. If you are using an 8-cm disc, place it on the inner circular border on the tray. Press the drive eject button or lightly push the center of the drive tray to replace the tray inside the drive. [. . . ] There are six regions around the world as illustrated by the map below. This DVD drive can be changed to play a DVD from any region in the world but can ONLY be changed five times. This restriction makes the drive adaptable for use in any region while still maintaining compliance with RPC-II regulations. The ability to switch from one region to another is not an ongoing feature. [. . . ]