User manual ASUS E975

[. . . ] E975 High-Speed CD-ROM Drive ATAPI / Enhanced IDE Interface With Quick Installation Guides in 12 different languages USER'SMANUAL COPYRIGHTS/DISCLAIMER Copyright © 2002 THE MANUFACTURER. No part of this manual, including the products and software described in it, may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means, except documentation kept by the purchaser for backup purposes, without the express written permission of THE MANUFACTURER. THE MANUFACTURER PROVIDES THIS MANUAL "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OR CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL THE MANUFACTURER, ITS DIRECTORS, OFFICERS, EMPLOYEES OR AGENTS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES (INCLUDING DAMAGES FOR LOSS OF PROFITS, LOSS OF BUSINESS, LOSS OF USE OR DATA, INTERRUPTION OF BUSINESS AND THE LIKE), EVEN IF THE MANUFACTURER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES ARISING FROM ANY DEFECT OR ERROR IN THIS MANUAL OR PRODUCT. [. . . ] Under Options of the Settings tab, click DMA to enable DMA Mode. Your CD-ROM drive reads data at different speeds depending on the disc format. Your CD-ROM drive performs at its best when it is reading a CD-ROM or CDROM format disc. With other formats, such as Audio CD or Video CD, data transfer rate performance may be slower than the maximum rate performance specified. Cannot display the directory on an audio CD disc with the DIR command. The DIR command does not work with audio CD discs while in DOS. You can use the command, however, to display the directory on a data CD. NOTE: You can use the DIR command to display the directory on an audio disc while in Windows using the command prompt or MS-DOS Prompt. Refer to your Windows manual on how to find the command prompt. 14 High-Speed CD-ROM Drive User's Manual ENGLISH . I. QUICK INSTALLATION GUIDE Hardware Installation 1. Turn off your computer and peripheral devices, such as your printer. If you do not have one, touch both of your hands to a safely grounded object or to a metal object on your system. Set your drive as either the Master or Slave (default) drive by placing the jumper cap on the desired jumper. Insert the CD-ROM Drive into one of the free 5. 25-inch bays available for disk drives. Connect an unused power supply cable to the back of your CD-ROM Drive. Connect the 40-pin IDE ribbon cable to the back of your CD-ROM Drive. Make sure that the red stripe on the cable is aligned to Pin 1 of the IDE connector. If you have a sound card, connect the 4-pin CD audio cable to the CD-ROM Drive's Analog Audio line out connector. If you do not have a sound card, plug earphones, headphones, or powered/self-amplified speakers to the Headphones Jack on your CD-ROM's front panel. Set the volume controls of your drive and powered/selfamplified speakers to minimum before starting or restarting your computer. If you removed any drive or other items other than your CD-ROM Drive, put them back into place and secure them to your computer. Slide your CD-ROM Drive now into place and fasten it to your system with the screws provided. Replace the cover on your computer and secure it with the screws you removed earlier. [. . . ] Om du inte har ljudkort, sätt in hörlurar eller högtalarna med separat elkällan i Hörlurarsuttaget på CD-ROM-stationens frampanelen. Ställ in volym av din station och högtalarna med separat elkällan på minimum innan du startar elle startar om din dator. Om du har tagit bort några stationer eller andra delar förutom CD-ROM-stationen, återplacera dem och kontrollera att dem sitter fast. Sätt in din CD-ROM-station i utrymmet och fastskruva den till systemet med de befintliga skruvorna. [. . . ]