User manual ASUS F1A75-M PRO

[. . . ] If this Eric Lu equipment does cause interference to radio or television equipment reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: DECLARATION OF CONFORMITY Per FCC Part 2 Section 2. Address: 18305 Valley Blvd. , Suite#A LA Puent, CA 91744 Phone/Fax No: (818) 854-9338/ (818) 854-9339 hereby declares that the product Product Name: Mother Board Model Number: F1A75-M PRO Conforms to the following specifications: FCC Part 15, Subpart B, Section 15. 107(a) and Section 15. 109(a), Class B Digital Device Supplementary Information: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful and (2) this device must accept any inference received, including that may cause undesired operation. ERIC LU Representative Person's Name: Signature: Date: Jun. [. . . ] Press your mouse right button in "My Computer" and then select the "Properties" item. b. Click "Device Manager" item. 50 6OXM7E Series Motherboard c. Press "Sound, video and game controllers" item and th en select the "Creative Sound Blaster PCI128" item. d. Press "Settings" item and then select the "Output Mode" item. 51 Four Speaker & SPDIF Introduction e. Click "Digital" item, Line Out will be change to SPDIF Out. f. Recommend you to select "Autosense", it will auto detect the audio jack you plug in to Line Out is mono or stereo, and then change to SPDIF Out or Speaker out automatically. 52 Memory Installation Memory Installation The motherboard has 4 dual inline memory module (DIMM) sockets support 6 banks. The BIOS will automatically detects memory type and size. To install the memory module, just push it vertically into the DIMM Slot . The DIMM module can only fit in one direction due to the two notch. Install memory in any combination table: Location DIMM1 (Bank 0, 1) DIMM2 (Bank 2, 3) DIMM3 (Bank 4, 5) 168-pin SDRAM DIMM Modules Single ­ Sided Note Double ­ Sided Single ­ Sided Double ­ Sided Single ­ Sided Double ­ Sided DIMM4 Single ­ Sided (Bank 4, 5) Double ­ Sided Total System Memory (Max 512MB) DIMM4 have only single-sided DIMM4 must be empty DIMM3 must install single-sided DIMM3 must be empty ¡¹ Supports 16 / 32 / 64 / 128 / 256/ 512 MB SDRAM DIMM Modules. When you're using single -sided memory on DIMM4, you must use single-sided memory on DIMM3. If you use double-sided memory on DIMM4, please do not insert any memory on DIMM3. 52 6OXM7E Series Motherboard $ Page Index for BIOS Setup Main Menu Standard CMOS Features Advanced BIOS Features Advanced Chipset Features Integrated Peripherals Power Management Setup PnP/ PCI Configurations PC Health Status Frequency / Voltage Control Load Fail-Safe Defaults Load Optimized Defaults Set Supervisor / User Password Save & Exit Setup EXIT Without Saving Page P. 55 P. 58 P. 62 P. 65 P. 68 P. 73 P. 77 P. 79 P. 81 P. 82 P. 83 P. 84 P. 85 P. 86 53 BIOS Setup BIOS Setup BIOS Setup is an overview of the BIOS Setup Program. If you select User Type, related information will be asked to enter to the following items. Enter the information directly from the keyboard and press <Enter>. Such information should be provided in the documentation form your hard disk vendor or the system manufacturer. Number of cylinders HEADS number of heads PRECOMP write precomp LANDZONE Landing zone SECTORS number of sectors If a hard disk has not been installed select NONE and press <Enter>. · Drive A / Drive B The category identifies the types of floppy disk drive A or drive B that has been installed in the computer. No floppy drive installed 5. 25 inch PC-type standard drive; 360K byte capacity. 5. 25 inch AT-type high-density drive; 1. 2M byte capacity (3. 5 inch when 3 Mode is Enabled). 3. 5 inch double-sided drive; 720K byte capacity 3. 5 inch double-sided drive; 1. 44M byte capacity. 3. 5 inch double-sided drive; 2. 88M byte capacity. 60 6OXM7E Series Motherboard · Floppy 3 Mode Support (for Japan Area) Disabled Drive A Drive B Both Normal Floppy Drive. Drive A & B are 3 mode Floppy Drives. · Video The category detects the type of adapter used for the primary system monitor that must match your video display card and monitor. Although secondary monitors are supported, you do not have to select the type in setup. EGA/VGA CGA 40 CGA 80 MONO Enhanced Graphics Adapter/Video Graphics Array. [. . . ] To disable password, just press <Enter> when you are prompted to enter password. A message "PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is disabled, the system will boot and you can enter Setup freely. If you select "System" at "Security Option" in BIOS Features Setup Menu, you will be prompted for the password every time the system is rebooted or any time you try to enter Setup Menu. [. . . ]